User manual GEMINI CDM-3700G

[. . . ] CAUTION: This product satisfies FCC regulations when shielded cables and connectors are used to connect the unit to other equipment. To prevent electromagnetic interference with electric appliances such as radios and televisions, use shielded cables and connectors for connections. the exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The lightening flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] HEADPHONE OUTPUTS: The HEADPHONE OUTPUTS located at rear center and front center of the CDM-3700G will accept any headphone with a standard 1/4" connector and or adaptor and will allow you to CUE your music program before you play it, you can adjust the volume and PGM mix of the HEADPHONE (see CONTROLS) below. MIC (MICROPHONE) INPUTS: There are two microphone (MIC) inputs on the CDM-3700G, MIC (1) is located on the front panel and will accept any UNBALANCED 1/4" connector, MIC(2) is located on the back panel and will accept any balanced and unbalanced XLR as well a standard 1/4" connector. You can control the gain for either MIC separately (See MIXER SECTION ). Do not use this CD player at temperatures below 41°F/5°C or higher than 95°F/35°C. The apparatus should not be exposed to dripping or splashing, and no objects filled with liquids such as vases should be placed on the apparatus. When disconnecting the power cord from the AC outlet, always grasp it by the plug. To prevent electric shock, do not remove the cover or the bottom screws. POWER: Once you have connected all your cables and made sure that the VOLTAGE SELECTION SWITCH is set correctly, you can turn the CDM-3700G on by pressing the POWER button, pressing the CDM-3700G's POWER button a second time will turn off the unit. DISC TRAY: The DISC TRAY is where the CD is held during loading, unloading and playback, and holds both 12 cm and 8cm CD's. VOLTAGE SELECTION SWITCH Before plugging the CDM-3700G into any wall outlet, make sure that the VOLTAGE SELECTION SWITCH is set to the proper voltage. To change this selection unscrew the hard plastic protective top with a Phillips head screw driver. Then use a flat head screw driver to move the switch to the proper selection (115V or 230V) . Excessive force may cause damage, if the switch does not move smoothly, contact a qualified technician. EJECT BUTTON: Pressing the EJECT BUTTON will open or close the DISC TRAY, unless the CDM-3700G is in play mode, then you must first stop the side you which to eject. JOG WHEEL : In SEARCH MODE the JOG WHEEL can be used to search forward or backwards in the music track, as well as for fine adjustments to a CUE point in PAUSE mode. In PITCH BEND mode the JOG WHEEL will function the same as the PITCH BEND allowing you to speed up (FORWARD) or slow down (REWIND) the music clockwise (FORWARD) and counter clockwise (REWIND). jOG MODE BUTTON: When the JOG MODE BUTTON is illuminated it indicates the the JOG WHEEL is in SEARCH MODE , and when not illuminated it indicates that the JOG WHEEL is in PITCH BEND MODE. DISPLAY: The DISPLAY shows the track number, pitch value, pitch bend, single, continue (for continuous play), play/pause modes, fast forward/reverse modes, loop mode, reloop mode, PGM, repeat modes, the playback display bar, and three different time displays. These times displays are TIME ELAPSED on the track, TIME REMAINING on the disc and and TIME REMAINING on the track. To program a set list into the CDM-3700G memory, begin by stopping the unit from play and pressing PGM to begin the set list. Select a track by using the track selection button to scan to the first track to be placed in the set list. When you have released your loop the OUT BUTTON will turn OFF and the IN BUTTON will remain lit to indicate that your loop is stored in the CDM-3700G memory. [. . . ] Many cd's are recorded out of spec and will skip on most or all CD players. Before sending the unit for repair, try playing a CD that you are sure plays properly. IN THE UNITED KINGDOM In the event that you need service on your Gemini product under warranty, simply write a letter describing the problem, along with your contact information. Make sure to enclose a copy of your receipt for proof of warranty information. [. . . ]