User manual GATEWAY LD-220

[. . . ] For customer service and support, call 1-800-846-2301 between 7am - 10pm Centeral Time Monday through Friday If you need technical support after setting up your system, login to the Gateway Support website at http://suport. gateway. com INTRODUCTION UNPACKING AND INSTALLATION READ THIS BEFORE OPERATING YOUR UNIT This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Note to CATV System Installer : This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] STEREO MODE Press the CH SEL key (37/remote control) repeatedly, the following loop will be displayed on the display screen: OSD LANG CAPTIONS Refer to the above b, c, d, e, i in the 5. 1CH mode to adjust each audio channel output to select a satisfactory display effect. During setup, use the 4 shift keys and the functional key SELECT/ENTER on front panel or remote control, to complete your desired functional setting. DOWNMIX TEST TONE CNTR DELAY 17. PRO LOGIC ­ Before playing a CD, VCD, or 2CH DVD, make the following settings to get 4. 1CH output: L, C, R, SUB and S. Setting: SPEAKER SETUP to 5. 1CH, and PRO LOGIC to ON in AUDIO SETUP item. REAR DELAY STEREO 5. 1CH ON OFF -- -- 5MS -- --- -- 3MS -- --- -- 1MS -- -- OFF -- -- 15MS -- --- -- 9MS -- --- -- 3MS -- -- OFF MAIN PAGE www. gateway. com 20 FUNCTION AND OPERATION EXPLANATION AUDIO PAGE AUDIO OUT How to use menu picture ANALOG SPDIF/RAW SPDIF/PCM STEREO L-MONO R-MONO MIX-MONO -- -- Full -- --- -- 6/8 -- --- -- 4/8 -- --- -- 2/8 -- -- OFF OFF ON PROLOGIC VIRTUAL MUSIC MOVIE MATRIX CUST LPCM 48K LPCM 96K You can use the menu picture to make the initial setting, adjust the picture, etc. You can also set the captions and the subtitles, restrict the children playing, etc. This unit can display menu picture either in play mode or in stop mode. Use the key on remote control to select the item you want, then press the ENTER key on remote to confirm. (the color of the chosen item turns dark) GENERAL SETUP SPEAKER SETUP AUDIO SETUP PREFERENCES EXIT SETUP DUAL MONO DYNAMIC PRO LOGIC PRO LOGIC II LPCM OUTPUT PREFERENCES PAGE TV TYPE VIDEO OUTPUT AUDIO SUBTITLE DISC MENU PARENTAL PASSWORD MULTI NTSC PAL S-VIDEO YCbC ENGLISH FRENCH SPANISH CHINESE JAPANESE ENGLISH FRENCH SPANISH CHINESE JAPANESE ENGLISH FRENCH SPANISH CHINESE JAPANESE 1G 2 3 PG 4 PG 13 5 6 PG-R 7 NC-17 8 ADULT CHANGE DOWNMIX STEREO 5. 1CH MAIN PAGE DOWNMIX CNTR DELAY REAR DELAY TEST TONE MAIN PAGE STEREO 5. 1CH 3. Using the 4 arrow keys on remote control to selete your desired item, then press the ENTER key to confirm. Press the "SETUP" key on the remote control to exit setup. 21 www. gateway. com FUNCTION AND OPERATION EXPLANATION GENERAL SETUP Press the SETUP key on remote to enter ". . . MENU SETUP. . . MAIN PAGE. . . ". Use the 4 arrow keys and ENTER key to select your desired function setup. Preset the following items: TV DISPLAY NORMAL/PS NORMAL/LB WIDE ANGLE MARK For a DVD recorded with multi-angular scenes, you can change the angle of the screen. For example, when you play the DVD in which a motor car is going forward, without interrupting the moving scenes, you can display the scenes from the front window, left side window or right side window. ON mode: The current playing angle mark number displayed on the right-upper angle on the TV screen. OFF mode: No angle mark number is displayed on the TV screen. ANGLE MARK OSD LANG CAPTIONS SCR SAVER TV DISPLAY To select the screen format to fit your TV screen. NORMAL/PS(4:3 Pan Scan) Select this screen when this system is connects to normal TV set. The widescreen picture display on the full screen, but some parts of the video picture are cut off automatically. Note: The angle number differs from disc to disc or from scenes to scenes. With some discs recorded with multiangular, the angle may not be changed. OSD LANG The are different displaying languages, like English, Spanish, etc. Note: If the DVD disc playing does not have captions, this function is not valid. NORMAL/LB(4:3 Letter-box) Select this screen when this system is connected to normal TV set. The wide-screen picture displays, but there are black strips on top and bottom. SCR SAVER There are two modes ON/OFF in this unit system. Under the ON mode, if the stop or pause state is more than one minute during DVD function, SCR saver picture appears. The purpose of SCR SAVER is to protect the display screen from damage. [. . . ] and its subsidiaries and affiliates are intended beneficiaries of this Agreement. If there is any inconsistency between this Agreement and any other agreement included with or relating to products or services purchased from Gateway, this Agreement shall govern. This Agreement may not be modified, altered or amended without the written agreement of Gateway. Any additional or altered terms attached to your order shall be null and void, unless expressly agreed to in writing by Gateway. [. . . ]