User manual FLYMO SABRE SAW

[. . . ] Do not wear loose clothing or jewellery which can be caught in moving parts. Thoroughly inspect the area where the machine is to be used and remove all wires and other foreign objects. Before using the machine and after any impact, check for signs of wear or damage and repair as necessary. Never attempt to use an incomplete product or one with an unauthorised modification. [. . . ] Either of these reactions may cause you to lose control of the product, which could result in serious injury to the user. Use a firm grip with fingers and thumbs incircling the Sabre Saw handles 2) Do not over reach 3) Keep a proper footing and balance at all times 4) Do not let the nose of the guide bar contact a log, branch, ground or other obstructions 5) Use devices such as special guide bars that reduce the risks associated with kickback, as fitted to your product. 6) Only use replacement bars and chains specified by the manufacturer Maintenance and storage 1. Keep all nuts, bolts and screws tight to be sure the product is in safe working condition. Be careful during adjustment of the product to prevent entrapment of the fingers between moving blades and fixed parts of the machine. After use the product should be stored using the chain cover provided. Ensure that the Sabre Saw is switched off and disconnected from the Power Pack · Pull the cutting chain away from the guide bar. To adjust the tension, slightly loosen the hex socket head bolt (R) with the hexagon drive tool provided. Ensure that the Sabre Saw is switched off and disconnected from the Power Pack 1. Lubricate the whole of the cutting chain before each use, using the lubricating oil provided. Ensure that the Sabre Saw is switched off and disconnected from the Power Pack · Always wear gloves when removing or fitting the cutting chain. In order to prevent kickback, do not remove the bar tip or replace the guide bar with one without a bar tip. Loosen the screws (K1) on the sprocket guard (K2) with a screwdriver and remove the sprocket guard. Loosen the hex socket head bolt (L1) with the hexagon drive tool provided and remove the bolt (L1) and spacer washer (L2). Push the guide bar (L3) against the tension adjusting spring (L4) and remove the guide bar and chain. Fit the chain over the guide bar with the bar tip upermost (M1), ensuring that the cutters are facing the revolving direction (M2) 2. Fit the chain over the sprocket (N1) and fit the concave end of the guide bar against the tension adjusting spring (N2). Insert the hex socket head bolt (L1) through the spacer washer (L2), and guide bar (L3) and tighten with the hexagon drive tool provided, ensuring the guide bar is secure. Fit the sprocket guard (K2) and tighten the screws (K1) ensuring the sprocket guard is secure. Ensure that the Sabre Saw is switched off and disconnected from the Power Pack · Always wear gloves when sharpening the cutting chain · sHARPEN THE CUTTING CHAIN TO THE SPECIFICATIONS ILLUSTRATED IN PICTURE T Filing the cutters 1. apply it to the cutter so that it will be angled 30 degrees to the guide bar and protrude 1/5 of the outer diameter from the tip of the cutter. Be careful not to touch the cutters with the file when pulling it back toward you. [. . . ] (e) The machine has not been serviced or repaired, taken apart or tampered with by any person not authorised by Husqvarna Outdoor Products. * This guarantee is additional to , and in no way diminishes the customers statutory rights. Failures due to the following are not covered, therefore it is important that you read the instructions contained in this Operator's Manual and understand how to operate and maintain your machine: Failures not covered by guarantee * Failures as a result of not reporting an initial fault. * Failures as a result of not using the product in accordance with the instructions and recommendations contained in this Operator's Manual. [. . . ]