User manual FLYMO PAC A SHREDDER

[. . . ] Mains cables and extensions are available from your local Approved Service Centre. Avoid wearing loose-fitting clothing or that has hanging cords or ties. Before using the machine check that all screws, nuts, bolts and other fasteners are properly secured and guards and screens in place and in good working condition. [. . . ] Remove the plug from the mains : - before leaving the product unattended for any period or when transporting; - before clearing a blockage; - before checking, cleaning or working on the appliance; - if the product starts to vibrate abnormally or makes an unusual noise. Keep all nuts, bolts and screws tight to be sure the product is in safe working condition. Do not attempt to repair the product unless you are competent to do so. Be careful during folding of the product to prevent entrapment of the fingers between moving and fixed parts of the machine. Before operating the product, ensure the collection box is correctly located and the Interlock Switch (D1) is securely in place. The product will not start if the Interlock Switch is not located correctly. To stop the product, turn the control switch anticlockwise back to the O symbol (F1). A push stick is provided to feeding less bulky material into the Feed Inlet (G1) enabling the material to reach the cutting blade. overload Reset Button Overloading , jamming the product causes the machine to automatically stop. After a short period of time, press the reset button (H1) and restart the product. When the feed inlet is suddenly blocked, the direction or rotation may switch automatically. Clearing a Blockage The product is fitted with a reverse switch (J1) to enable the release of jammed material. Turn the control switch anti-clockwise to the symbol to put into reverse mode. Failure to do so may lead to serious damage to your product and result in your Warranty becoming void. Adjusting the Cutting Plate If branches and twigs are not being cut through cleanly, then adjustment of the Cutting Plate against the Cutting Blade is required. With the product running in the forward direction insert the hex key supplied into the hole at the side of the casing (L1). [. . . ] * The following items listed are considered as wearing parts and their life is dependent on regular maintenance and are, therefore not normally subject to a valid warranty claim: Blades, Electric Mains cable, Cutting Plate * Caution!Husqvarna Outdoor Products does not accept liability under the warranty for defects caused in whole or part, directly or indirectly by the fitting of replacement parts or additional parts that are not either manufactured or approved by Husqvarna Outdoor Products, or by the machine having been modified in any way. Se till att alla muttrar, bultar och skruvar är tillskruvade ordentligt för att se till att maskinen är säker för drift. [. . . ]