User manual FLYMO MT21

[. . . ] Never place your hands or feet underneath the deck or into the rear discharge chute while the engine is running. STARTING THE ENGINE Once the machine has been set up properly, start the engine as follows: a) Engines with choke system: when the engine is cold, position the accelerator lever on START b)Operate the engine stop lever (1) to prepare the engine for start, keep lever pressed against handle while starting and using the machine (it operates the engine brake). C) Engines with primer system: Press the fuel-enrichment pump (16) located on the carburettor or times position the accelerator lever on MAX. For further information and explanations, read carefully the user instruction manual of the engine. [. . . ] Hold the engine start-grip (11) and pull the starter rope gently until you feel the resistance caused by compression. Return the starter rope slowly then pull the handle firmly towards you to its full extent. MOWING To cut the grass, push the lawn mower manually Keep the engine stop lever (14) depressed during machine operation. MOWING To cut the grass, push the lawn mower manually or insert the automatic advance gear. How to insert automatic advance: Lift up the clutch handle (18) and keep it pressed in position. Important: If, when you press the clutch lever, the automatic advance gear does not engage, the clutch cable should be adjusted by inserting the spring (P) in one of the subsequent holes in the plate (R) (or in the hole "S" . Periodically check the automatic advance assembly and make sure to keep it clean. In particular, the pinion (17) and the gear (18) must be kept perfectly clean. To carry out this check, you must remove the wheel (19) by unscrewing the screw (0). Safe Operation Practices for Pedestrian-Controlled Rotary Lawnmowers IMPORTANT: This cutting machine is ca pa ble of amputat ng hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death. Stop the engine: - whenever you leave the lawnmower; - before refuelling. Reduce the throttle setting during en gine shut down and, if the engine is provided with a shut-off valve, turn the fuel off at the conclusion of mowing. Maintenance and Storage Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. Never store the equipment with petrol in the tank inside a building where fumes may reach an open flame or spark. To reduce the fire hazard, keep the engine, silencer, battery compartment and petrol storage area free of grass, leaves, or excessive grease. Switch off the motor and disconnect the spark plug before undertaking any maintenance work. For a four stroke engine, check the oil level and change the oil when dirty. Frequently check the mower and ensure that all grass deposits are removed from beneath the deck. Never clean the mower by pouring water over it: this may seriously damage the electric start system. Frequently remove the wheel screws clean whith petroleum and oil before replacing. Check the conditions of the blade-support (), the washer (), the key () and the washer (6) and replace any parts which are damaged. [. . . ] Frequently remove the wheel screws clean whith petroleum and oil before replacing. Check the conditions of the blade-support (), the washer (), the key () and the washer (6) and replace any parts which are damaged. When reassembling, make sure that the key () is correctly seated in the shaft and that the cutting edges face in the direction of the engine rotation. If any part is found to be defective due to faulty manufacture within the guarantee period, Husqvarna Outdoor Products Italia Spa, through its Authorised Service Repairers will effect the repair or replacement to the customer free of charge providing: a) The fault is reported directly to the Authorised Repairer. [. . . ]