User manual FISHMAN SWITCHJACK

[. . . ] INSTALLATION GUIDE www. fishman. com Installation of this product is a simple procedure, but we recommend this job only if you are an experienced repair technician. [. . . ] When you insert a plug, the negative battery wire connects to ground via the sleeve, and the system switches on. Preliminary To gain better access to the Tip, Ring and Switch terminals, gently bend back the Strain Relief/Sleeve tab before soldering (figure 2). Figure 1. Follow this sequence when you install the endpin jack (figure 3): 1. Adjust the backing nut so the larger threads are about 6" shy of the outside of the endblock (figure 4). Thread the dress washer and dress nut, then insert a 332" (2. 3 mm) or smaller diameter shaft through the small cross-drilled holes. Tighten the nut with a ½" open end wrench while you hold the jack in place with the shaft. [. . . ] End of jack is proud, large threads are shy Wiring Options Passive pickup Active pickup Two passive pickups, stereo Active + passive pickup, stereo Passive pickup + mini-mic, stereo Active pickup + mini mic, stereo www. fishman. com 009-074-002 Rev B 4-07 [. . . ]