User manual EWAVE MCWC30M

[. . . ] · Always consider instructions stated in sections Positioning and Energy Saving Tips, otherwise the energy consumption is substantially higher. · Remove shipping bracket at base of door opening and replace the foot before operating this appliance. Tips for Energy Saving · Try not to open the door too often, especially when the weather is hot and humid. · Every now and then check if the appliance is sufficiently ventilated ( adequate air circulation behind the appliance ). · Set the thermostat from higher to lower settings as soon as possible (depends on how loaded the appliance is, ambient temperatures etc. ). [. . . ] The plug must be plugged into an appropriate wall outlet that is installed and wired in accordance with all existing local codes and ordinances. Consult a qualified electrician or serviceman if the wiring instruction are not clearly understood, or if doubt exists as to whether the appliance is properly earthed. INSTALLATION Place the appliance firmly on a solid base. Some appliances have adjustable feet on the front side; use them to level the appliance. CONNECTION TO POWER SUPPLY Connect the appliance power cord and plug to a properly earthed wall outlet. The required nominal voltage and frequency are indicated on the rating plate (inside the unit or on the exterior rear wall of the unit). 4 Description of the appliance (A) Adjustable Wire Shelves (The number of shelves depends on the model) Shelves can be optionally placed on the guides inside the appliance. Perishable items should be stored towards the back/rear of the shelves. (B) Defrost Water Outlet The interior of the appliance is cooled with a cooling plate mounted in the rear wall. Regularly check the defrost water outlet and the drain channel for blockage. WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO EFFECT ON THE OPERATION OF THE APPLIANCE. Temperature Control The temperature of the appliance is controlled by setting the thermostat knob to a desired setting. Temperature Selection To start the appliance turn the temperature control knob to the position corresponding to the desired cooling. Fig A (MCWC16M) see page 6 Fig B (MCWC30M) see page 6 The temperature will vary depending on the quantity of the item stored and on the frequency with which the door is opened. 5 To turn the control to the "OFF" position, rotate the control knob to the "0" position. If the appliance has been left out of use for some time, set the control to maximum or the "7" position for 2-3 hours before turning to the desired position. If the appliance is not being used for long time periods, disconnect the plug and leave the door partially open. This will help to reduce mold/mildew from accumulating inside the appliance cabinet. CONTROL KNOB Fig A (MCWC16M) Fig B (MCWC30M) . Changes in ambient room temperature will affect the internal temperatures (choose correct setting of the thermostat knob). In STOP (0) position the appliance does not operate (cooling system is switched off ), yet power supply is not interrupted. Temperature in the appliance also depends on how often the door is opened. THERMOSTAT DIAL: For controlling the temperature inside the wine cooler. Turns the motor on as soon as the temperature rises above the desired level. PLASTIC COATED SHELVES: Odor resistant, rustproof, and removable for easy cleaning. MAGNETIC GASKET: Tight fitting door seal keeps all the cooling power locked inside. [. . . ] Contact the closest authorized service agent in your area for assistance. Ice Formation on the Inner Rear Wall As long as the defrost water runs to the channel and through the outlet to the drain pan on the compressor, automatic defrosting of the appliance is assured. In case the ice formation on the inner back wall is increased (1/8-1/5in. ), ice should be manually defrosted. Set the thermostat knob to STOP ( 0 ) position and leave the door open. Never use electric devices for defrosting and do not scrape the ice or frost layer with sharp objects. [. . . ]