User manual EMTEC EKCOH180

[. . . ] Insert 2 AAA alkaline batteries, verify that they are placed correctly with the + on the battery in the same position as marked inside the battery compartment. [1] LED indicator: Theindicatorlightflasheswhentheremoteisoperatingor lights continuously while you are programming the remote. [3] TV, VCR, DVD, SAT: These keys allow you to select the appliance you wish to control. Press and release the Shift key, the LED will stay on indicating the Shift mode, press then the function keys you want. [. . . ] In any case, follow the steps below: Make sure your equipment is switched on (for example TV). Press and hold the SETUP (4) key until the LED indicator (1) lights continuously. Press and release the mode key (3) of the device you want to control (for example TV). If you entered a wrong code the LED blinks for 3 seconds and then goes off. If certain functions are not responding this indicates that the entered code is not the correct one. In that case repeat the above procedure with the next corresponding code of your brand. Repeat this procedure from step 1 for the other equipment you want to control (TV, VCR, DVD, SAT) 5) Manual code search If your equipment (TV, SAT etc. : If you want to program a SAT under the VCR key, enter any SAT code found in the code book and then follow the steps below: Make sure your equipment is switched on. Press the mode key (3) that matches the equipment you want to control (for example TV). If you step past the correct code use PROG - (7) to go back to the right code. Note: If your equipment doesn't have PROG +, you can use PLAY (VCR or DVD) (17) or POWER (2) key. If that was 0030, the search starts at 0031 until the last possible code and then goes from 0000 to 0029. Note: if certain functions of your equipment can't be controlled you havetofindadifferentcodeforyourbrand. 6) Automatic code search When searching an unknown code, you can step through the library automatically (AutoSearch). When your equipment responds, you can stop the searching process and store the code you found. ) to the VCR, DVDorSATkeys, youneedfirsttoenterany4digitcodefor the kind of appliance you wish to control (found in the code book, i. : If you want to program a SAT under the VCR key, enter any SAT code found in the code book and then follow the steps below: 1. Press the mode key (3) that matches the equipment you want to control (for example TV). After a few seconds the remote starts stepping through the code library (fast search, 1 code per second). When the device responds, you can press PROG+ (7) to switch to slow search (1 code per 3 seconds). [. . . ] You can program the remote control so that the volume control is functional for each mode selected (the volume control must exist on the corresponding device). Control of the television set sound in TV mode, control of the SAT receiver sound in SAT mode, . Make sure that you have pressed the corresponding mode key of the equipment or device that you want to control. â· If the listed code does not work , try the AUTOSEARCH method or enter the next code of that brand. [. . . ]