User manual ELECTRO-VOICE ND767A EDS

[. . . ] N/D767a Vocal Microphone General Product Description The new N/D767a presents optimal performance in a live sound environment. The 767a vocal microphone utilizes EV's new VOBTM (vocally optimized bass) technology to provide the performer with reduced low-end distortion and eliminates the muddiness found in other microphones. [. . . ] These are merely guidelines to assist in the placement of the microphone to gain optimal performance. Usage Vocals Spoken Word Optimal Placement Zero to six inches from the windscreen, and on axis with the microphone. Five to ten inches from the windscreen, and on axis with microphone. N/DYM W I R E ® D MICROPHONES N/D767a Vocal Microphone Specifications Element Frequency Response Close Response Far Response Polar Pattern Impedance Sensitivity Open Circuit Voltage Power Level Microphone Connector Polarity Finish Materials MemraflexTM grille screen Warm-GripTM handle Dimensions Length Diameter Shank Weight Net Shipping Accessories included Stand adapter (black) Soft zippered "gig" bag Dynamic N/DYM® magnet structure 35 Hz to 22 kHz 70 Hz to 22 kHz Supercardioid Low-Z balanced (300 Ohms) 3. 1 mV/Pascal @ 1. 0 kHz (0 dB=1mW/pascal) -51 dB 3-pin, XLR-type Pin 2 positive, referenced to pin 3 with positive pressure on diaphragm Non-reflecting black Standard Placement & Use Guidelines 1. Always point the microphone at the desired source of sound, and away from any unwanted sources. 2. The microphone should be located close to the sound source to minimize interference from other potential sound sources. Place each microphone three times farther from other microphones as from the desired sound source. Minimize over-handling of the microphone to reduce unwanted mechanical noise 5. Working close to the microphone will increase the bass tone and also provide increased gain-before-feedback. Warranty This product is guaranteed against malfunction from any cause for two (2) years from the date of original purchase. [. . . ] For customer orders, contact the Customer Service department at 800/392-3497 Fax: 800/955-6831 For warranty repair or service information, contact the Service Repair department at 800/685-2606 For technical assistance, contact Technical Support at 800/392-3497 Please refer to the Engineering Data Sheet for warranty information. [. . . ]