User manual ELECTRO-VOICE ND478 EDS

[. . . ] N/D478 General Product Description Instrumental Microphone N/DYM W I R E ® The N/D478's acoustic response presents optimal performance in both a live sound or studio environment. The new "vocally optimized bass" or VOBTM technology provides the instrumentalist with reduced resonant distortion at low frequencies. [. . . ] On double headed Toms place mic over the top of drum 1-3" and at a 45° angle to the drum surface and 1-2" in from the drum edge. On single headed Toms use above method or place mic inside Tom from underneath at a 90° angle from the center of head, 3-5", away. If the drum rings, tape deadening material to the head or use damping rings. For more "snare" sound place a 2nd mic underneath aimed up at the bottom of head. Place mic 6-12" from where finger board joins the body. N/D478 Instrumental Microphone Specifications Element Frequency Response Close Response Far Response Polar Pattern Impedance Sensitivity Open Circuit Voltage Power Level Microphone Connector Polarity Finish Materials MemraflexTM grille screen Warm-GripTM handle Dimensions Length Diameter Shank Weight Net Shipping Accessories included Stand adapter (black) Soft zippered "gig" bag Dynamic N/DYM® magnet structure 45 Hz to 15 kHz 100 Hz to 15 kHz Cardioid Low-Z balanced (300 Ohms) 2. 9 mV/Pascal @ 1. 0 kHz (0 dB=1mW/pascal) -51. 5 dB 3-pin, XLR-type Pin 2 positive, referenced to pin 3 with positive pressure on diaphragm Non-reflecting black Standard Placement & Use Guidelines 1. Always point the microphone at the desired source of sound, and away from any unwanted sources. 2. The microphone should be located close to the sound source to minimize interference from other potential sound sources. Place each microphone three times farther from other microphones as from the desired sound source. [. . . ] For customer orders, contact the Customer Service department at 800/392-3497 Fax: 800/955-6831 For warranty repair or service information, contact the Service Repair department at 800/685-2606 For technical assistance, contact Technical Support at 800/392-3497 Please refer to the Engineering Data Sheet for warranty information. [. . . ]