User manual ELECTRO-VOICE ND468 (WIRED) EDS

[. . . ] N/D468 General Product Description Instrumental Microphone N/DYM W I R E ® Designed specifically for horns, drums, acoustical and electric guitars, the N/D468 provides a smooth, natural sound, capturing the excitement of the instrument. The supercardioid pattern provides superior rejection and acoustic isolation in any application. [. . . ] On single headed Toms use above method or place mic inside Tom from underneath at a 90° angle from the center of head, 3-5", away. If the drum rings, tape deadening material to the head or use damping rings. For more "snare" sound place a 2nd mic underneath aimed up at the bottom of head. Place mic 6-12" from where finger board joins the body. N/D468 Instrumental Microphone Specifications Element Frequency Response Close Response Far Response Polar Pattern Impedance Sensitivity Open Circuit Voltage Power Level Microphone Connector Equivalent Output Noise Polarity Finish Materials MemraflexTM grille screen Dimensions Length Diameter Shank Weight Net Shipping Accessories included 311 stand clamp Soft zippered "gig" bag Dynamic N/DYM® magnet structure 30 Hz to 22 kHz 60 Hz to 22 kHz Supercardioid Low-Z balanced (150 Ohms) 3. 1 mV/Pascal @ 1. 0 kHz (0 dB=1mW/pascal) -51dB @ 1. 0 kHZ 3-pin, XLR-type 14 dB A weighted (0 dB=0. 00002 pascal) Positive pressure on diaphragm causes Positive voltage on pin 2 ref. Pin 3 Non-reflecting black Standard Placement & Use Guidelines 1. Always point the microphone at the desired source of sound, and away from any unwanted sources. 2. The microphone should be located close to the sound source to minimize interference from other potential sound sources. Place each microphone three times farther from other microphones as from the desired sound source. [. . . ] For customer orders, contact the Customer Service department at 800/392-3497 Fax: 800/955-6831 For warranty repair or service information, contact the Service Repair department at 800/685-2606 For technical assistance, contact Technical Support at 800/392-3497 Please refer to the Engineering Data Sheet for warranty information. [. . . ]