User manual ELECTRO-VOICE CM-1 EDS

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ELECTRO-VOICE CM-1 EDS. We hope that this ELECTRO-VOICE CM-1 EDS user guide will be useful to you.


ELECTRO-VOICE CM-1 EDS : Download the complete user guide (140 Ko)

Manual abstract: user guide ELECTRO-VOICE CM-1 EDS

Detailed instructions for use are in the User's Guide.

[. . . ] CM-1 CobraNetTM Interface Module Key Features: · 100BASE-TX Ethernet Interface ­ 100Mbit/s full-duplex Ethernet Interface; IEEE 802. 3u compatible. [. . . ] Status LEDs ­ Link, Activity, Fault and CobraNetTM Conductor status indication via Ethernet connectors. · · · · · General Description: CobraNetTM is a network technology for multichannel transmission of digital audio data. The CM1 is a compact interface module for connection to a CobraNetTM network allowing the simultaneous transmission of up to 32 digital audio input signals and 32 digital audio output signals. Technical Specifications: Supply Voltage / Current 3. 3 V DC, ±0. 3 V / 1. 2 A 5 V DC, ±0. 25 V / 0. 1 A Ethernet Connectors RJ-45, integrated transformer (Primary / Secondary) isolation, IEEE 802. 3u Standard Sample Rate 48 kHz Data Format 16 / 20 / 24 Bit Operating Temperature Range 0 °C . . . 40 °C Dimensions (W x H x D) 89mm x 27mm x 92mm 3. 50" x 1. 06" x 3. 62" Weight 75 g (0. 17 lb) Status LEDs: Yellow: Interface in use Blinking: Device is a CobraNetTM Conductor Green: Link okay Blinking: Communication active Fatal Error: Yellow LEDs on both sockets flashing Block Diagram: POWER SUPPLY +3. 3V +5V 24. 576 MHz CM-1 Block Diagram VCXO MODULE INTERFACE PHY FPGA PRIMARY RJ-45 HOST / SERIAL MAC SRAM FLASH COBRANET INTERFACE PHY SECONDARY RJ-45 AUDIO IN AUDIO OUT 4 x 8 Channels 4 x 8 Channels DSP Installation: 1. Remove cover plate (6 screws on the sides, 3 screws on top, 4 screws on the rear) 3. Install the CM-1 module (see picture); first, secure it with 2 screws on the rear panel (A), then with 2 screws on the bolt (B), tighten the screws 5. Make the following cable connections: - J1 on CM-1 module with CN28 on main board 80500 (65mm flat wire cable) (C) - J3 on CM-1 module with CN5 on DSP-Board 80496 (190mm flat wire cable) (D) 6. [. . . ] For customer orders, contact Customer Service at: + 1 952 884-4051 Fax: + 1 952 736-4212 For warranty repair or service information, contact the Service Repair department at: 800/685-2606 For technical assistance, contact Technical Support at: 866/78AUDIO Specifications subject to change without notice. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ELECTRO-VOICE CM-1 EDS




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ELECTRO-VOICE CM-1 EDS will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.