User manual EBENCH KH 2341 DESIGNER AUDIO UNIT WITH CD PLAYER

[. . . ] If the device is not to be used for an extended period, be sure to disconnect it from the mains and remove the batteries. Pull the plug out of the mains socket to properly disconnect the device from the electricity supply. Protect the mains lead from hot surfaces or other sources of damage and do not allow it to become constrained. The rubber feet may become stuck to or softened by the material used for or used to clean the supporting surface. [. . . ] The device is now ready for operation and can be switched on and off (Stand-By) using the button W on the front of the device. Insert the mains plug into the mains socket and move the switch into position "I". The device is now ready for operation and can be switched on and off (Stand-By) using the button W on the front of the device. If you switch the power supply off at the main switch then any stored data such as time and radio presets will be lost. When the power supply is switched on at the main switch (position I), the device goes into Stand-By mode. Press the ON/OFF switch (Stand-By) button W again to switch off the device. If the device is not to be used for an extended period, pull the mains plug out of the mains socket. The Display briefly shows "VOL ON" and then changes back to the last operating mode (e. The functions of the buttons on the remote control handset are identical with those on the device. A strong light source in the room may adversely affect the remote control functions. ­ Open the battery compartment in the back of the remote control handset as described there and remove the discharged battery ­ Insert the new battery, making sure that the polarity is correct (+ pole of the battery points upwards) ­ Close the battery compartment again Avoid pressing more than one function button at a time as otherwise this could reduce the service life of your handset. If the handset is not to be used for an extended period, remove the battery from the battery compartment. Use the tone selector button q to set the tone quality of a track to suit the type of music and increase listening pleasure. the current setting Rock/Jazz/Classic/Pop is shown in the display R (FLAT = neutral tone). Note: On model KH 2341, the Tone can be selected only using the remote control handset. 8-32 Ohm stereo headphones A can be connected to the headphones connector with a 3. As soon as the headphones are connected the loudspeakers are turned off. Please note that high levels of sound can lead to serious hearing damage. You can adjust the volume by using the Volume control or the appropriate button on the remote control handset. Press the Memory button } once more and the Minutes display starts to flash. Note: If you do not perform the setting within 5 seconds the process is cancelled. If this happens, press the Memory button } again to repeat the process. [. . . ] Never use petrol, solvents or cleaning agents that might attack plastic. Please contact your local council office to find out about disposal facilities for your worn-out appliances. Battery users are obliged by law to take all unwanted rechargeable and non-rechargeable batteries to a collection point operated by a public authority or a retailer. This law is intended to ensure that batteries are disposed of in an environmentally-friendly manner. [. . . ]