User manual EBENCH KH 2074

[. . . ] Fixez le support mural ensuite au moyen du matériel de fixation fourni sur un mur approprié; placez ensuite la caméra sur la vis sans tête se trouvant à l'extrémité supérieure du support et fixez-la au moyen de la vis moletée (voir figure ). Read these operating instructions through carefully before using your surveillance camera set for the first time and keep them in a safe place for future reference. Do not dismantle a surveillance camera or its components since there is a danger of an electric shock. [. . . ] First of all, attach the aerials to the jacks on the back of the receiver and the camera and make sure they are firmly in place. Then mount the wall bracket onto a suitable wall using the fastening material included; place the camera on the set screw at the top end of the bracket and tighten it using the knurled screw (see Fig. Now connect the power supply cable to the power cable of the mains adapter and then insert this in a mains socket. Connect the receiver to a television set using the SCART-cable, connect the power supply cable of the mains adapter to the receiver and insert the mains adapter in a socket. When the receiver is switched on, a red control LED lights up on the front, showing the device is ready for operation. Note: Outside, the transmission range of the camera is up to 100 metres, inside buildings it depends to a great extent on the construction materials used. Tip: If your television set only has one SCART connection and you would like to operate other devices with it besides your new eBench surveillance camera (video recorder, DVD player etc. ), you can connect the receiver of your surveillance camera system between video recorder or DVD player and television set. To do this, connect the receiver SCART-cable to the television set and the video recorder or DVD player to the receiver per SCART-cable. When the receiver is switched on, the signal of the camera will be received, interrupting the signal of the video recorder or DVD player. When the receiver is switched off, the television set will receive the AV signal again. Once you have connected all the components together, camera and receiver must now be set to the same channel. Remove the rubber cover from over the channel selection switch on the back of the camera. Choose the required channel by sliding the required switch to ON on the back of the device (see Figure ). If you have selected channel 1 for the first camera, you must select channels 2-4 respectively for the other cameras. If several cameras are in operation, you can use the "T" switch on the back of the receiver to change the interval at which the receiver changes channels (4 or 8 seconds), i. [. . . ] C) If a microwave or other electromagnetic device is in operation, switch it off and check your surveillance system again. D) Change the channel set on the camera and receiver, in other words switch both to channel 3 or 4; note that the camera and receiver must always be switched to the same channel. 21, D-44867 Bochum, Germany, hereby declare that this product conforms with all the applicable international safety standards, regulations and EC directives. [. . . ]