User manual EAGLE INTELLIMAP 642C IGPS INSTALLATION NOTES

[. . . ] 988-0152-161 www. eaglegps. com IntelliMap® 642c iGPS Mapping GPS Receiver Installation and Operation Instructions Copyright © 2005 LEI-Eagle All rights reserved. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Eagle Electronics. Any unauthorized commercial distribution of this manual is strictly prohibited. LakeMaster and ProMaps are trademarks or registered trademarks of Waypoint Technologies, Inc. [. . . ] 9, Searching, for more instructions. ) After you have looked up an item with the Find Waypoint command, use to make sure the GO TO command is highlighted at the bottom of the screen, then press ENT. To cancel navigation, press MENU|MENU| to CANCEL NAVIGATION|ENT| to YES|ENT. The unit stops showing navigation information. Creating and Saving a Trail A trail or plot trail, is a string of position points plotted by the unit as you travel. They are particularly handy when you are trying to retrace your trip and go back the way you came. On the screen, trails are represented by a solid line extending from the back of the current position arrow. The default color is light magenta. 44 The unit is set to automatically create and record a trail when it is turned on. The unit will continue recording the trail until the length reaches the maximum trail point setting. The default is 2, 000 points, but the unit can record trails 9, 999 points long. When the point limit is reached, the unit begins recording the trail over itself. With the default auto setting, this unit creates a trail by placing a dot on the screen every time you change directions. The methods used for creating a trail and the trail update rate can be adjusted or even turned off. To preserve a trail from point A to point B, you must turn off the trail by making it inactive before heading to point C or even back to point A. When the current trail is set inactive, the unit automatically begins recording a new trail. Press MENU|MENU| to MY TRAILS|ENT. Visible symbol Active symbol Sequence for saving a trail and beginning a new one. The arrow to the right of Trail 3 indicates the trail is active and the check to the left indicates the trail is visible on the map display. The third figure (right) shows the Edit Trail menu, with the Name command selected. 2. As you leave the Edit Trail menu, a new trail starts with a new sequential number. You can save and recall up to 10 different plot trails, which can be copied to your MMC for archiving or for transfer to your MapCreate software. 45 Tip: Another quick way to stop recording one trail and begin a new one is to use the New Trail command. Press MENU|MENU| to MY TRAILS|ENT|ENT. Caution: You also have the option of completely turning off trail recording, under the trail Options command. If, however, the Update Active Trail option is left turned off, it will cancel the automatic trail creation feature. Displaying a Saved Trail The active trail is automatically displayed on the with the default settings. You can selectively turn trail display off and on for any saved or active trail. In the Saved Trails List, visible trails have a check mark in front of the trail name. [. . . ] If you're in the United States and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 800-324-1354 8 a. m. [. . . ]