User manual EAGLE INTELLIMAP 480 Operation Instruction

[. . . ] 988-0143-741 www. eaglesonar. com IntelliMap 480 Mapping GPS Receiver Installation and Operation Instructions Copyright © 2003 Eagle Electronics All rights reserved. Eagle® is a registered trademark of Eagle Electronics Navionics is a registered trademark of Navionics, Inc. Points of Interest Data in this unit are by infoUSA, copyright 2001-2003, All Rights Reserved. infoUSA is a trademark of infoUSA, Inc. eXitSource Database, copyright 2001-2003 Zenrin Co. Ltd. Eagle Electronics may find it necessary to change or end our policies, regulations, and special offers at any time. [. . . ] The 40-mile zoom, center, shows both current position and destination on screen. The Navigation Page, right, will also show navigation information. To stop navigating to the cursor, use the Cancel Navigation command: press MENU|MENU| to CANCEL NAVIGATION|ENT| to YES|ENT. The unit stops showing navigation information. Navigate to a Point of Interest For POIs that are in view on the map, you can easily use the Navigate to Cursor command above; just use the cursor to select the POI. The other method involves searching for POIs with the Find Waypoint command, launched with the WPT key. 6, Searching, for detailed instructions on POI searches. ) After you have looked up an item with the Find Waypoint command, use or to make sure the GO TO WAYPOINT command is highlighted at the top of the screen, then press ENT. To cancel navigation, press MENU|MENU| to CANCEL NAVIGATION|ENT| to YES|ENT. The unit stops showing navigation information. Creating and Saving a Trail a trail, or plot trail, is a string of position points plotted by the unit as you travel. They are 42 particularly handy when you are trying to retrace your trip and go back the way you came. On the screen, trails are represented by a solid line extending from the back of the current position arrow. The unit is set at the factory to automatically create and record a trail while the unit is turned on. The unit will continue recording the trail until the length reaches the maximum trail point setting (default is 2, 000, but the unit can record trails 9, 999 points long). When the point limit is reached, the unit begins recording the trail over itself. By default, the trail flashes once a second, making it easier to see against the background map. With the default auto setting, this unit creates a trail by placing a dot (trail point) on the screen every time you change directions. (The methods used for creating a trail and the trail update rate can both be adjusted or even turned off. 5 for Trail Options. ) To preserve a trail from point a to point B, you must "turn off" the trail by making it inactive before heading to point C or even back to point a. When the current trail is set inactive, the unit automatically creates and begins recording a new trail. Press MENU|MENU| to MY TRAILS|ENT. Visible symbol Active symbol Sequence for saving a trail and beginning a new one. The arrow to the right of Trail 14 indicates the trail is "active, " and the check to the left indicates the trail is visible on the map display. The right figure shows the Edit Trail menu, with the Active command selected. 2. As you leave the Edit Trail menu, you will notice that a new trail starts with a new sequential number. In the example figure below, the new trail is number 15, showing zero points. [. . . ] If you're in the United States and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 800-324-1354 8 a. m. [. . . ]