User manual DMC S1
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual DMC S1. We hope that this DMC S1 user guide will be useful to you.
Manual abstract: user guide DMC S1
Detailed instructions for use are in the User's Guide.
[. . . ] OWNER S MANUAL
IMPORTANT NOTICE
WELCOME
Thank you for purchasing an Daelim vehicle. We hope you enjoy safe riding.
OPERATOR AND PASSENGER
This motorcycle is designed to carry the operator and one passenger.
WARNING
Attempting to change the pre-set maximum speed may cause danger and will void the Daelim warranty.
ON-ROAD USE
This motorcycle is designed to be used only on the road.
READ THIS OWNER'S MANUAL CAREFULLY
Pay special attention to statements preceded by the following words:
WARNING
Indicates a strong possibility of severe personal injury or death if instructions are not followed.
CAUTION
Indicates a possibility of personal injury or equipment damage if instructions are not followed.
NOTE
Gives helpful information. keep it with your vehicle at all times, even though your vehicle is resold.
2
CONTENTS
SPECIFICATION OPERATION INSTRUCTION
SAFETY PRECAUTIONS
PRIOR TO STARTING VEHICLE OPERATION CORRECT ATTIRE CARGO MODIFICATION ATTACHMENT MUFFLER 3 4 4 5 5 6 6 7 7 7 8 10 10 10 10 10 11 11 12 12 13 13 13
EQUIPMENT USAGE
STEERING STEM LOCK SEAT LOCK TRUNK DOCUMENT STORAGE AREA BAG HOLDER
14 14 14 15 15 15 16 16 18 19 20 21 23 24 24 25 26 27 28 28 30 30
CORRECT DRIVING OPERATION
STARTING THE ENGINE IF ENGINE CANNOT BE STARTED AFTER STARTING ENGINE PROPER DRIVING METHODS STOPPING
PARTS LOCATION METER READING AND USAGE
METER INDICATOR LAMPS SIDE STAND LAMP MALFUNCTION INDICATOR LAMP
SELF INSPECTIONS BEFORE OPERATION
INSPECTION OF CONCENED AREA BRAKE INSPECTION FUEL CHECK TIRE INSPECTION ENGINE OIL LEVEL CHECK LIGHTS AND WINKER INSPECTION BULB REPLACEMENT METHOD REAR VIEW MIRROR FUEL LEAK INSPECTION
SWITCH OPERATION
MAIN SWITCH START BUTTON HEADLIGHT WINKER SWITCH HORN BUTTON PASSING SWITCH
1
MAINTENANCE
MAINTENANCE SCHEDULE MAINTENANCE PRECAUTIONS BRAKES BRAKE HOSE, PIPE LEAKAGE, DAMAGE, ASSEMBLY STATE BRAKE PAD WEAR CHANGING ENGINE OIL TRANSMISSION OIL INSPECTION WHEEL REMOVAL CHANGING COOLING WATER SPARK PLUG BATTERY INSPECTION FUSE REPLACEMENT COUPLER CONNECTION AIR CLEANER ELEMENT INSPECTION SIDE STAND INSPECTION CABLE RUBBER PART CLEANING GENERAL CLEANING / IMPORTANT STORAGE GUIDE FRAME AND ENGINE NUMBER
31 32 34 34 36 36 37 38 39 41 41 42 43 44 44 45 45 46 47 47 48
SAFE DRIVING PREPARATION BEFORE DRIVING DRIVING METHOD
DRIVING POSITION TAKING POSE OF FELLOW PASSENGER PRECAUTION WHEN DRIVING STARTING
49 49 50 50 51 52 53 54 54 54 55 56 57 58 58 58 59 59 59 60
TURNING METHOD
PRINCIPLE OF TURN EFFECT OF SPEED 3 POSITIONS OF TURNING TURNING METHOD PRECAUTION WHEN TURNING
BRAKING METHOD
BASIC PRINCIPLE OF BRAKE(FRICTION FORCE) RESTRAINT OF BRAKING EFFECT (INERTIA) BRAKING METHOD COMPARISION OF BRAKING DISTANCE IMPACT WHEN COLLISION
WIRING DIAGRAM
2
SPECIFICATION
ITEM
LENGTH WIDTH HEIGHT(mm) WHEEL BASE(mm) GROUND CLEARANCE(mm) SEAT HEIGHT(mm) DRY WEIGHT(kgf) PASSENGER ENGINE TYPE PISTON DISPLACEMENT(cc) BORE AND STROKE(mm) STARTING SYSTEM TRANSMISSION TYPE
DATA
1. 965 702 1. 120 1. 350 126 770 127 2 OIL- COOLED/AIR- COOLED 4 STROKE 4VALVE 124. 9 56 50. 7 START MOTOR V - MATIC
ITEM
IGNITION SYSTEM BATTERY CAPACITY FUEL CAPACITY( ) RESERVE FUEL CAPACITY( ) TIRE SIZE FR. BRAKE SPARK PLUG FUSE(A) RR.
DATA
TRANSISTOR 12V10AH(MF TYPE) 9. 6 2. 2 120 / 70 - 13 130 / 60 - 13 TELESCOPIC UNIT SWING OIL DAMPER HYDRAULIC DISK HYDRAULIC DISK CR8EH-9 30A, 15A
3
OPERATION INSTRUCTION
This manual describes matters pertaining to correct operation, safe operation and simple maintenance of the vehicle you purchased. [. . . ] Check a stop lamp for proper operation by operating the front wheel and the rear wheel brakes, and also a lens for damage or contamination.
<HEADLIGHT BULB>
(1) Loosen 7 special screws and disassemble the electric wire of the headlight and remove the front cover.
BULB REPLACEMENT METHOD
Be sure to turn a main switch "OFF" prior to replacement of a bulb. After replacement with new bulb, check for proper operation.
CAUTION
Care is to be taken to avoid leaving fingerprints on a headlight bulb. Failing to observe this may cause early damage of the headlight bulb resulted from concentration of heat. If touched to it with bare hands, clean it with a cloth soaked with alcohol to prevent from early damage.
<INSPECTION OF WINKER>
Turn a main switch "ON". Check the lamp for proper operation (front/rear and right/left) and sound by operating the switch, and also a lens for damage or contamination.
28
(2) Disassemble a headlight socket by pulling it out. (4) Loosen the steel wire, and disassemble the head light bulb.
HEADLIGHT BULB: 12V 55W
<HEADLIGHT ILLUMINATION ANGLE>
Adjust headlight illumination angle by turning an adjusting bolt on a headlight. (Use type screwdriver. ) (1) Adjust the upper/lower by turning the screw on outside. (2) Adjust the right/left by turning the screw on inside.
<TAIL/STOP LIGHT BULB>
(1) Loosen 2 tapping screws to disassemble tail light lens. (2) Press a bulb with a light force and rotate it to counterclockwise to disassemble it. Apply reverse order of disassembly for assembly.
TAIL/STOP LIGHT BULB : 12V 21/5W
CAUTION
Illumination angle adjusted incorrectly may dazzle a facing driver's eyes or result in difficulty to show the forward.
(5) Replace with new bulb. (6) Install in the reverse order of remover.
CAUTION
When disassembling, care is to be taken for ensuring that a tail light lens can not be damaged. When replacing a tail light lens, be sure to assemble lens seal securely.
29
<WINKER BULB>
Front Winker Bulb (1) Loosen tapping screw to disassemble a winker lens. (2) Press a bulb with a light force and rotate it to counterclockwise to disassemble it. Apply reverse order of disassembly for assembly.
FRONT WINKER BULB: 12V 10W
order of disassembly for assembly.
REAR WINKER BULB: 12V 10W
REAR VIEW MIRROR
Check the objects at the back are well noticed when seating on a driver's seat, and also mirror for damage or contamination. Rear Winker Bulb (1) Loosen two tapping screws to disassemble a tail light lens and a winker lens. (2) Press a bulb with a light force and rotate it to counterclockwise to disassemble it. Apply reverse
FUEL LEAK INSPECTION
Check there is no gasoline leakage from fuel tank, hoses, carburetor, etc.
30
MAINTENANCE
The Required Maintenance Schedule specifies how often you should have your motorcycle served, and what things need attention. It is essential that your motorcycle be served as scheduled to retain its high level of safety, dependability, and emission control performance. These instructions are based on the assumption that the motorcycle will be used exclusively for its designed purpose. Sustained high speed operation, or operation in unusually wet or dusty conditions, will require more frequent service than specified in the MAINTENANCE SCHEDULE. Consult your authorized Daelim dealer for recommendations applicable to your individual needs and use.
31
MAINTENANCE SCHEDULE
Perform the Self Inspections Before Operation at each scheduled maintenance period. I: INSPECT AND, CLEAN, ADJUST, LUBRICATE OR REPLACE IF NECESSARY R: REPLACE L: LUBRICATE C: CLEAN FREQUENCY ITEM FUEL LINE THROTTLE OPERATION AIR CLEANER ELEMENT SPARK PLUG ENGINE OIL ENGINE OIL FILTER OIL FILTER SCREEN TRANSMISSION OIL BRAKE FLUID VALVE CLEARANCE I R R C R I I I I
1, 000Km MONTH
ODOMETER READING(NOTE1)
1 1 4 6 8 12 12 18 16 24
REMARK
I I
I I R I R R C
I I R I R R C R I I
I I R I R R C I I
I I R I R R C R R I
32
FREQUENCY ITEM BRAKE SHOE / PAD WEAR BRAKE SYSTEM BRAKE STOP SWITCH HEADLIGHT ADJUSTMENT SUSPENSION BOLTS, NUTS, FASTENERS WHEELS / TIRES STEERING DRIVE VALTE WEIGHT ROLLER SLIDE PIECE MOVABLE DRIVE FACE GREASE
1, 000Km MONTH
ODOMETER READING(NOTE 1)
1 1 4 6 8 12 12 18 16 24
REMARK
I I I I I I
I I I I I I I I I I I L
I I I I I I I I I I I L
I I I I I I I I I I I L
I I I I I I I I I I I L
If you do not have the appropriate tools or information to conduct maintenance, or if you feel you are not capable to perform maintenance on this vehicle, contact authorized dealers or repair shops for maintenance and repairs. [. . . ] Feet : Place the feet to face the front parallel and make the step bar be placed in the center of feet.
1 2 3 4 5 6
50
TAKING POSE OF FELLOW PASSENGER
Hands: Hold the rear grip. Feet and knees: Put the feet on pillion step, and adhere the knees closely to body.
WARNING
If the fellow passenger doesn't hold the rear grip or put the step on the pillion step, it may lead death or serious injury due to falling from the vehicle as sudden start, stop or turning. If the fellow passenger sit on and the rear wheel touch the ground, it may lead death or serious injury due to sudden start.
51
PRECAUTION WHEN DRIVING
Secure the safe distance. If any abnormality is found, stop driving and contact service center to inspect the vehicle. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE DMC S1
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual DMC S1 will begin.