User manual DLS IC236 2010-10-28

[. . . ] Install the speakers yourself if you feel confident with our instructions and if you have the proper tools. If you feel unsure, turn over the installation job to someone better suited to it. [. . . ] Just make sure that the damping material don´t fall into the speaker, especially in roof mount installations. Check that the damping material meet the local fire and building regulations. Avoid placing roof mounted speakers closer to a wall or corner than 50 cm (20"). Make sure the cables don´t get jammed causing a short circuit as this can damage the output circuits of your amplifier. If you connect more than one speaker in series or parallel, make sure the resulting impedance is in accordance with your amplifier specifications. Power 2x4 ohm 2x4 ohm 50 W 60 W Max power 100 W 120 W Sensitivity 90 dB 91 dB Magnet size 90 mm / 3, 54" 100 mm / 4" Installation depth 75 mm / 3"" 82 mm / 3, 23" Mounting hole cut out size 192 mm / 7, 56" 192 mm / 7, 56" Outer size Dimension 228 mm / 8, 98" 210 mm / 8, 30" IC236 IC636 Anslut + kabeln till den röda terminalen och - kabeln till den svarta. Use the template coming with the speaker to cut or saw a hole for the speaker frame. the speaker accepts a material thicknes of 10 - 33 mm (0 , 4-1 , 3"). Remove the grille from the plastic frame by pushing two of the wings from the backside. The screws that became visible when you removed the grille, has wings attached that will swing out behind the wall or roof panel when you turn the screws clockwise. Don´t tighten the screws too hard, there is a risk that you deform the plastic frame. When installed in a soft panel in the ceiling, use a piece of MDF or particle board to reinforce the installation. [. . . ] For technical assistance, ask the shop where the product was sold, or the distributor in your very country. For this reason all or part of specifications & designs may be changed without prior notice. [. . . ]