User manual DIRTDEVIL UD70010

[. . . ] Ifapplianceisnotworkingasitshould, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center for inspection. Donotusewithanyopeningblocked;keep free of dust, lint, hair, and anything that may reduce air flow. Vacuumcleanermustbeintheuprightpositiontolifttherotatingbrushoffthe carpet when doing above floor cleaning. Ifunintendedoperationofthe*propulsionshouldoccur-Returnthecleanerhandle to the full upright position and/or turn off power to the cleaner at the foot pedal switch. [. . . ] Thiswarrantygivesyouspecificlegalrightsandyoumayalsohaveotherrights(Otherrights may vary from state to state in the USA). Insert the two (2) screws into the front of the back panel andtightenuntilsecure(Diagram2a). Attach tools: (a) Slide the dust brush onto post on the upper tool caddy with bristles facing out. (c) Slide the extension wand/crevice tool into round slot on the front right side of tool caddy. Keep hair, loose clothing, fingers, and all parts of body away from brush area while cleaner is on. Cleaner must be in the upright position to lift the rotation brush off the carpet when cleaning above the floor. Turn cleaner on by depressing foot pedal located on the back left side of the cleaner. To release handle, push the handle release pedal located on the lower left side of the cleaner. Settings: For maximum cleaning performance, the following carpet height settings are recommended: · lowestsetting:foralltypesofcarpet. Note: If the cleaner is difficult to push, turnknobtothenexthighersetting. Higher settings: for very deep pile carpet, where easier pushing effort is desired, while maintaining good cleaning performance. Simply push the attachment firmly onto the end of the wand or hose handle. Move the handle and adjust it to the desired position for (a) storing the upright, (b) operating the cleaner, and (c) de-press the handle release pedal again to clean under furniture. Allow filter to COMPLETELY DRY for at least 24 hours before replacing in filter cartridge. If vacuum is used frequently, the filter may require more frequent cleaning. Press dirt container release button on back of cleaner to remove the dirt container. For F51 filter replacement, please call 1-800-321-1134 or visit our website at www. Hold dirt container over garbage can and press clean release dirt container button to empty. [. . . ] Plug cleaner in and check to see if there is any suction at end of hose (Diagram 1). If there is no suction at the end of hose, clear dirt path window and lower hose. Slip the O-ring into the groove at the neck of the Turbo Tool/Power Brushtocompletereassembly. Performance Indicator light has turned red Cleaner won't pick-up or low suction Cleaner is difficult to push Costsof any transportation to and from any place of repair are to be paid by the owner. [. . . ]