User manual DIRTDEVIL PD20020

[. . . ] â· Do not use the product on leather, wax polished furniture or floors, synthetic fabrics, velvet or other delicate, steam sensitive materials. â· Do not fill water tank under running water, use only manufacturer's supplied fill cup. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service When using an electrical appliance, basic precautions should always be followed, including the following: WARNING: Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. [. . . ] The warranty does not include unusual wear, damage resulting from accident or unreasonable use of the vacuum cleaner. This warranty does not cover brushes, bags, flat belts, filters and bulbs. This warranty gives you specific legal rights and you may also have other rights (Other rights may vary from state to state in the USA). Main body Main on/off button Red On light Green pilot light indicating steam ready Steam flow regulator control Safety stopper Horizontal parking groove Accessory Holder Wheels Extension tube support (parking vertical) Steam plug Steam gun Main steam nozzle Steam release button Steam release blockage button Button for connection/ disconnecting accessories Extension tubes Buttons for attaching/detaching the extension tubes Power cable Pad connector Pad Flaps holding pad cloth Never leave the appliance plugged in when filling or emptying. â· Unscrew Safety Stopper (F) by pressing down and turning slightly in a counter-clockwise direction (Fig. NOTE: In hard water areas, or to prevent calcium and mineral deposits from accumulating on the heating element and mop head, you may use distilled or demineralized water in place of tap water. â· Pour in water using the measuring cup and funnel supplied. Put steam gun (L) in place, attaching it to the base using steam plug (K)(Fig. Press steam release button (N), making sure that steam release button (O) is not jammed (Fig. NOTE: When pressing steam release button (N) for the first time or after a certain amount of time out of use, a few drops of water may form due to the initial heat instability. This is normal and is simply caused by steam condensation in the conducts. If this occurs, it is advisable to release the steam into a cloth, keeping steam release button (N) pressed and then wait a few seconds until the droplets disappear. Switch off the appliance by pressing the general on/off button (B), ensuring that the red pilot light has gone off and then unplug the power supply cable from outlet. â· Eliminate the steam pressure, pressing steam release button (N). â· Slowly unscrew the safety stopper (F) to enable the remaining steam that might be in the water to be released slowly. â· Screw Safety Stopper (F) by pressing down and turning in a counter-clockwise direction until cap is on securely. The steamer is fitted with a series of built in accessories in the accessory holder compartment (Fig. NOTE: The steam gun (L) is equipped with a steam block button (O), so that the steamer is not used accidentally or inappropriately. If the steam release button (O) is jammed, steam release button (N) cannot be enabled. Line up the main steam nozzle (M) with extension tube (Q) on the end fitted with the corresponding attachment. â· Press extension tube (Q) against the main steam nozzle (M) until you hear a click (Fig. Repeat this procedure if it is necessary to attach more tubes, using the Buttons to attach/detach extension tubes (R). [. . . ] The round plastic brush is specifically intended for use on delicate surfaces and is not recommended for use on floors or rough surfaces. â· Use round brushes (AA) with cloth brush (AB) to dry the surface being cleaned. Directly attach by pressure to concentrator nozzle (Y), making sure the marks are lined up. Hook the notches on the inside of this accessory onto fabric brush (AC). [. . . ]