User manual DIGITECH BASS HARMONY MACHINE

[. . . ] Refer to labels on the unit, including bottom cover, for Fax: (801) 568-7583 other markings and pertinent information. Bass Squeeze all (requires Class II power adapter that conforms to the requirements of EN60065, EN60742, or equivalent. ) WARRANTY: We at DigiTech are proud of our products and back-up each one with the following warranty: 1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DigiTech warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. DigiTech liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned to DigiTech WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a period of one year (this warranty is extended to a period of six years when the product has been properly registered by mail or through our website). A Return Authorization number may be obtained from DigiTech by telephone. The company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly. [. . . ] DigiTech reserves the right to make changes in design, or make additions to, or improvements upon this product without incurring any obligation to install the same on products previously manufactured. 6. The consumer forfeits the benefits of this warranty if the product's main assembly is opened and tampered with by anyone other than a certified DigiTech technician or, if the product is used with AC voltages outside of the range suggested by the manufacturer. 7. The foregoing is in lieu of all other warranties, expressed or implied, and DigiTech neither assumes nor authorizes any person to assume any obligation or liability in connection with the sale of this product. In no event shall DigiTech or its dealers be liable for special or consequential damages or from any delay in the performance of this warranty due to causes beyond their control. NOTE:The information contained in this manual is subject to change at any time without notification. Some information contained in this manual may also be inaccurate due to undocumented changes in the product or operating system since this version of the manual was completed. The information contained in this version of the owner's manual supersedes all previous versions. The Bass Squeeze Compressor is a studio quality, dual-band compressor for bass guitar. Featuring dbx® dynamics processing courtesy of DigiTech's AudioDNATM DSP engine, the Bass Squeeze provides the versatility you will need for a variety of applications. Whether you are mildly compressing the lows and highs, or doing radical tone shaping, you will find that the Bass Squeeze will be an indispensible part of your rig. Turn this knob clockwise to increase the output level, and counter-clockwise to decrease output level. Pedal Release Pins These two pins are spring-loaded hinges that hold the pedal in place. Push either pin in to release the pedal from the chassis, exposing the battery compartment. If the LED becomes dim or does not light when the cables are connected, the battery needs to be replaced. 11. Out 2 (Mixer) Jack This output features DigiTech's CITTM cabinet modeling technology, that lets you run the pedal directly into a mixer or recorder input without having to use a bass amplifier. Connections The Bass Squeeze has a single input (INPUT) and a pair of outputs (AMP and MIXER). The two outputs give you the following options: running into a bass amplifier, running directly to a mixing console or recording device, or both. The MIXER output uses DigiTech's advance CITTM cabinet modeling technology for an authentic bass amplifier sound without using an amp. Follow these setup directions: 1. Turn the volume down on the amplifier/mixer you are connecting to. 5. Turn the LEVEL knob on the pedal to the maximum position and the LO and HI BAND knobs to the minimum position. 6. Turn up your amplifier/mixer level to the listening level. [. . . ] 5. Turn the LEVEL knob on the pedal to the maximum position and the LO and HI BAND knobs to the minimum position. 6. Turn up your amplifier/mixer level to the listening level. 7. Turn on the pedal by pressing the pedal switch, and gradually turn up the LO and HI BAND knobs and adjust the LEVEL knob to a desired listening level. Sample Settings Thick Bottom Glass Top Mild Compression Battery Replacement 1. Using the tip of a 1/4"cable, push one of the release pins in on either side of the pedal, and remove the pedal from the pedal chassis. Remove the battery from the battery compartment and disconnect the battery cable. [. . . ]