User manual DAXTEN VOYAGER 100

[. . . ] If your computer does not have a PS/2 mouse or keyboard port, you can use a PS/2 to USB converter (2141-01U). The keyboard and mouse that you connect to the Voyager unit must be PS/2. With the constant changes in computers keyboards and mice on the market, it is impossible to guarantee universal compatibility for the Voyager's keyboard/mouse emulation. The Voyager emulation is compatible with almost all standard PC (Intel/AMD based) BIOS systems. [. . . ] Orientation: Looking into the RJ45 socket pin 1 is on the left and pin 8 on the right. Pin 1 2 3 4 5 6 7 8 Wire Colour White/Orange Orange/White White/Green Blue/White White/Blue Green/White White/Brown Brown/White Wire T2 R2 T3 R1 T1 R3 T4 R4 Pair 2 2 3 1 1 3 4 4 The Voyager has been tested with all major makes of CAT 5 cable including BICC-VERO, Mohawk, and Brand-Rex. The Voyager has also been tested with most major makes of CAT 5E and CAT6 with good results. Note: That failure to wire the twisted pairs correctly will impair the video quality dramatically and / or prevent correct operation. This Voyager 100 extender is designed for use up to a maximum cable length of 100m/330ft At this length the video quality should still be acceptable even at a screen resolution of 1280 x 1024 (85 Hz). Although a single continuous length of interconnect cable is preferable, operation is possible through multiple Patch Panels. However, the more patch panels the cable is routed through, the greater the chance of video signal degradation. Quick Setup System Guide Connecting Up 1. Connect the Voyager Local Unit to the PC KVM Cable Plug in your Keyboard, Monitor and Mouse into the corresponding Keyboard, Monitor and Mouse ports on the Voyager Local Unit. (You can use the Voyager without having a Local Keyboard, Monitor and Mouse connected). Connect the PC KVM cable to your computer's Keyboard Monitor and Mouse ports. Plug in your Keyboard, Monitor and Mouse into the corresponding Keyboard, Monitor and Mouse ports on the Voyager Remote Unit. Adjust the Video Equalisation if required on the Voyager Remote Unit which contains video equalisation circuitry that will compensate for the loss in image quality experienced when sending video over long cables. 4. 11. To set the correct level of equalisation there is an adjustment wheel on the rear side of the Voyager Remote Unit. Select and adjust the range appropriate to the cable length (these only need to be set once. ) Switch Position 0 1 2 3 4-9 Cable Length 0 ­ 30 m 0 ­ 100 ft 30 ­ 50 m 100 ­ 150 ft 50 ­ 70 m 150 ­ 230 ft 70 ­ 100 m 230 ­ 330 ft 70 ­ 100 m 230 ­ 330 ft The remote unit (when installed in its final location) may be left permanently powered up. Please note that for all practical purposes cable equalisation cannot be exact - the remote image will never be as sharp as the original. The Voyager's equalisation system is designed so that it produces very good results on short to medium length cables and an acceptable quality over longer cables. Note: If you are at the top end of a cable length range, say 45m, you may achieve a better quality video compensation by selecting the next cable length range, e. g. setting the switch to position 2 instead of position 1. Service Information Technical Support If you cannot determine the nature of a problem, please call Daxten and ask for Technical Support. If possible, call from a phone located near the unit, as we may be able to solve your problem directly over the phone. If we cannot solve your problem, and determine that the fault is in the unit, we will issue a Return Material Authorisation (RMA) number that must appear on the outside of all returned products. [. . . ] If the product is used in contradiction to any instruction provided by any User Guide or Instruction Sheet provided to you or with the product. EXCEPT AS SPECIFICALLY PROVIDED ABOVE AND TO THE MAXIMUM EXTENT ALLOWED BY LAW, DAXTEN DISCLAIMS ALL WARRANTIES AND CONDITIONS WHETHER EXPRESS, IMPLIED, OR STATUTORY AS TO ANY MATTER WHATSOEVER INCLUDING, WITHOUT LIMITATION, TITLE, NON-INFRINGEMENT, CONDITION, MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR OR INTENDED PURPOSE. EXCEPT AS EXPRESSLY PROVIDED ABOVE AND TO THE MAXIMUM EXTENT ALLOWED BY LAW, DAXTEN SHALL NOT BE LIABLE FOR ANY SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES (INCLUDING WITHOUT LIMITATION, LOSS OF PROFIT, LOSS OF BUSINESS, LOSS OF INFORMATION, FINANCIAL LOSS, PERSONAL INJURY, LOSS OF PRIVACY OR NEGLIGENCE) WHICH MAY BE CAUSED BY OR RELATED TO, DIRECTLY OR INDIRECTLY, THE USE OF A PRODUCT OR SERVICE, THE INABILITY TO USE A PRODUCT OR SERVICE, INADEQUACY OF A PRODUCT OR SERVICE FOR ANY PURPOSE OR USE THEREOF OR BY ANY DEFECT OR DEFICIENCY THEREIN EVEN IF DAXTEN OR AN AUTHORIZED DAXTEN DEALER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES OR LOSSES. Waste Electrical and Electronic Equipment (WEEE) Within the European this symbol indicates that this product should not be disposed in household waste. It should be deposited at an appropriate facility to enable recovery and recycling. [. . . ]