User manual DANBY SPAC8499

[. . . ] Portable 4 Season Home Comfort Model · Modèle · Modelo The model number can be found on the serial plate located on the back panel of the unit. All repair parts available for purchase or special order when you visit your nearest service depot. To request service and/or the location of the service depot nearest you, call the TOLL FREE NUMBER. When requesting service or ordering parts, always provide the following information: SPAC8499 For service, contact your nearest service depot or call: 1-800-263-2629 to recommend a depot in your area. · · · · Product Type Model Number Part Number Part Description Appareil de confort au foyer portatif 4 saisons Le numéro de modèle se trouve sur la plaque d'information sur la paroi arrière de l'appareil. [. . . ] When the desired time is established, (the time will flash in the display window) press the CLOCK key pad to register the AUTO TIMERON program. The word ON will stop flashing and remain "on" (TIMER ON) indicating the program is set. The time of day clock setting will immediately revert back in the display window. The unit must remain "OFF" while programming the AUTO-OFF program. The display window will indicate TIMER-OFF and the word OFF will flash for 5 seconds. When the desired time is established, (the time will flash in the display window) press the CLOCK key pad to register the AUTO TIMEROFF program. The word OFF will stop flashing and remain "on" (TIMER OFF) indicating the program is set. The time of day clock setting will immediately revert back in the display window. When the AUTO-ON & AUTO-OFF times are set, within the same program sequence, the display window shows TIMER ON OFF identifying that both ON and OFF times are now programmed (Repeatable daily until until such time the program is canceled and/or changed). IMPORTANT: The desired AUTO-ON & AUTOOFF time must be registered within a 5 second period (after pressing the TIMER-ON/OFF key pads) otherwise the selected time will not register and the system will automatically revert back to the regular "time of day" clock setting The unit will start automatically when the specified AUTO-ON time is achieved on the time of day clock and will stop automatically when the specified AUTO-OFF time is achieved on the time of day clock. To cancel or override the AUTO-TIMED program, simply turn the unit on or off prior to the scheduled AUTO-ON/OFF time. You can verify the AUTO-ON/OFF time selection anytime by pressing each respective TIMER-ON/TIMER-OFF key pad and the selected time will temporarily appear replacing the time of day clock for approximately 5 seconds. 18 Remote Control Features The hand held remote unit allows you to control all operational aspects (excluding Auto-Timed Programs) of your Portable 4 Season Home Comfort Appliance from the convenience of your favorite armchair. Here are some things you should know about operating the unit with the hand held remote. MODE Upper Control Buttons I/O: Power switch (On/Off). Mode: Selects the operating mode (Auto­Cool­Dry/Dehumidifier­Heat­Fan). The "auto" mode is a built in feature activated from the hand held remote unit only. Under "auto" mode, your unit will automatically select the required operating mode based on temperature selection. Dehumidifying mode is not operational under the "auto" mode function. The main unit will respond automatically, switching appropriately between modes "cool-heat-fan" to maintain the selected temperature. NOTE: The "Auto" fan speed setting is equivalent to "Medium" fan speed. Used to adjust (increase) both time of day clock settings and temperature settings. (2° increments) on the Fahrenheit scale. TEMP/TIMER FAN I/O TEMP/TIMER MODE I/O FAN TEMP/TIMER SWING CLOCK L R SET SWING CLOCK L R SET To operate the remote, you will require two "AAA" Alkaline batteries (included). Batteries should be replaced when: a) No signal (beep) is heard while attempting to program the main unit. b) No symbol " " appears in the remote LCD window when a command is initiated. [. . . ] Cependant, le moteur de ventilation fonctionne toujours (ceci est normal). Enlevez soigneusement le réservoir d'eau du caisson et déversez l'eau. Replacez le réservoir d'eau à sa bonne position (dans le caisson). Un délai normal de 3 à 5 minutes peut se produire avant la mise en marche du compresseur. Cool/Heat/Dry 10¡c SWING OFF CLOCK Température Fig. [. . . ]