User manual DANBY DPAC9030

[. . . ] Portable 3 Season Home Comfort Model · Modèle · Modelo · Modelo The model number can be found on the serial plate located on the back panel of the unit. All repair parts available for purchase or special order when you visit your nearest service depot. To request service and/or the location of the service depot nearest you, call the TOLL FREE NUMBER. When requesting service or ordering parts, always provide the following information: · · · · Product Type Model Number Part Number Part Description DPAC9030 DPAC12030 For service, contact your nearest service depot or call: 1-800-26- Danby (1-800-263-2629) to recommend a depot in your area. R Appareil de confort au foyer portable 3 saisons Le numéro de modèle se trouve sur la plaque d'information sur le panneau arrière de l'appareil. [. . . ] Under AUTO mode the unit will alternate between appropriate modes, COOL, DRY, FAN, to maintain internal environment conditions at the pre-set 24C (75F) temperature conditions. NOTE: The "Auto" fan speed setting is equivalent to "Medium" fan speed. (1° increments) on the Farenheight scale. Battery replacement: 1. Continue pulling (gently) until the cover separates completely from the unit. Insert (2) batteries (AAA) following the same orientation (polarity) depicted inside the battery chamber. (+/-) 3. If the remote control will not be used for extended periods of time (vacations etc. ), batteries should be removed. The remote operates within a range of 7 meters (23 ft. ) from the receiver located inside the main unit. Any obstruction between the receiver and remote may cause signal interference, limiting the ability to program the main unit. NOTE: The (illuminated) back-lit key pads on the main unit control panel will not illuminate when settings are made using the remote control unit. (this is normal) - SWING: Used to activate the vertical louver (oscillation) auto swing from side to side. To operate the hand held remote control will require two "AAA" Alkaline batteries (included ). Batteries should be replaced when: a) No signal (beep) is heard when attempting to program the main unit. b) The main unit does not respond to a command issued by the remote control. 17 Remote Control Operating Instructions 1. Sending Signal: The remote control must be aimed directly at the infra-red eye located below control panel when initiating a command. When the remote control is switched on and a button is pressed, a beep will sound (main unit) confirming a signal was sent/received. All program selections appearing in the remote control display will appear in the display of the main unit when both units are operational. If the main unit does not respond to the command issued, try the procedure again. If the main unit again fails to respond; Check the following: · Are the receiver and the remote unit within the required 7 meter (23 ft. ) operating distance?· Is the receiver window on the main unit partially blocked and/or obscured?· Are the batteries correctly installed inside the remote (positive+ / negative-)?Setting/Adjusting Time of Day Clock (Remote Control): When the batteries are first installed, the clock display flashes "0:00". Each time the MIN button is pressed the time is increased in 10 minute increments. [. . . ] 4. L'eau condensée sera accumulée dans les réservoirs externe et/ou interne. Quand le réservoir externe est plein, l'eau refoulera dans le réservoir interne. Quand le réservoir interne est plein, un signal d'alarme (bip) se fera entendre pendant 20 secondes et l'afficheur du Plein d'eau s'illuminera. À ce moment, la déshumidification cessera immédiatement. [. . . ]