User manual DANBY DPAC8399

[. . . ] The model number can be found on the serial plate located on the back panel of the unit. All repair parts available for purchase or special order when you visit your nearest service depot. To request service and/or the location of the service depot nearest you, call the TOLL FREE NUMBER. When requesting service or ordering parts, always provide the following information: CAUTION: Read and follow all safety rules and operating instructions before first use of this product. [. . . ] 2) Press the appropriate or key to select a suitable temperature between 17°C (63°F) to 30°C (88°F). 3) Press the FAN key to select the desired fan speed setting (High-Low). Each depression of the fan key will alternate between the different fan speed settings. 5) To adjust "air flow" direction, (up / down only) adjust any one of the Horizontal Louver Blades (excluding the top or bottom louver) and the remaining louvers will automatically adjust to the same position. Heating stops automatically when the room temperature reaches the desired setting. Heating will resume when the room temperature falls below the established temperature setting. Each depression of the MODE key will advance to a different mode setting (Cool-Dry-Heat-Fan). No indicator mode light is visible during operation of the FAN mode (this is normal). Each depression of the fan key will advance to a different speed (Low-Med-High). 5) To adjust "air flow" direction, (up / down only) adjust any one of the Horizontal Louver Blades (excluding the top and bottom louver) and the remaining louvers will automatically adjust to the same position. NOTE: Auto-Timed programs cannot be set with the hand held remote control. The TIME OF DAY CLOCK must be set before the AUTO-TIMER feature will operate. The AUTO-TIMER feature offers a unique selection of multiple choice, fully automatic on/off (start/stop) programs between 0 - 23 hrs, 50 min. The programs are as follows: a) Auto -Off: Pre-select a time that will turn off the unit (automatically) at a specified time (between 0 - 23 hrs, 50 min. This function must be performed daily, (if required) as the program is automatically canceled/erased upon completion. B) Auto-On: Pre-select a time that will turn on the unit (atomatically) at a specified time (between 0 - 23 hrs, 50 min. This function must be performed daily, (if required) as the program is automatically canceled/erased upon completion. C) Auto-On & Auto-Off: Pre-select a time that will turn on and turn off the unit (automatically) at specified times (between 0 - 23 hrs, 50 min. This program automatically stores into memory the selected times and will repeat daily, (same specified times) until the program is overridden and/or canceled. Any interruption to the electrical power supply of the unit automatically cancels/erases all auto timed programs. In the event this should happen, you will be required to re-set your program. Before setting the AUTO-ON timer, the TIME OF DAYCLOCK must be set/operational. [. . . ] Before cleaning or servicing this unit, it is recommended that the unit be disconnected from any electrical supply outlet. 1) Do Not use gasoline, benzene, thinner or any other chemicals to clean this unit , as these substances may cause damage to the finish and deformation of plastic parts. 2) Never attempt to clean the unit by pouring water directly over any of the surface areas, as this will cause deterioration of electrical components and wiring insulation. More frequent cleaning may be necessary depending upon indoor air quality. [. . . ]