User manual DANBY DPAC10061

[. . . ] 13 x TECHNICAL SPECIFICATIONS E-3 ENGLISH View of the Unit The figures are shown in this instruction may differ from yours depending on the model. Indoor Unit Air flow blades(outlet) Air inlet Air filter(under the grille) Timer indicator Remote control sensor Filter Sign indicator On/Off button On/Off indicator Fan indicator Removing frost indicator (Except Cooling Only Models) E-4 Outdoor Unit TYPE A Air outlet Connection valve Outdoor Unit TYPE B Air outlet Connection valve Outdoor Unit TYPE C Air outlet Connection valve Outdoor Unit TYPE D Air outlet Connection valve Outdoor Unit TYPE E Air outlet Connection valve Note If the heat exchanger in the outdoor unit gets dusty, cooling efficiency may fall. However, be careful when you wash the surface of the heat exchanger because it is very sharp. E-5 ENGLISH Wireless Remote Controller-Buttons and Display The wireless remote controller is an optional accessory. To use the wireless remote controller, refer to an appropriate manual. Operating mode Temperature setting Mode selection button Temperature adjustment buttons Filter Reset button Fan speed Air flow direction On Timer setting Off Timer setting Battery discharge indicator Fan speed adjustment button Swing button On Timer button Off Timer button On/Off & Timer Set/Cancel button Note - After cleaning the air filter, press the filter reset button. [. . . ] To use the wired remote controller, refer to an appropriate manual. Operating mode Removing frost indicator (Except Cooling Only Models) Centralized controller indicator (In case of installing the Centralized controller) Communication error indicator On Timer setting Off Timer setting Test indicator Temperature adjustment buttons On Timer button Off Timer button Test button Mode selection button Note - Test button is for your installation specialist. Then the wired remote controller will display the FILTER SIGN indicator when the time to clean the air filter; refer to page 11. - The heating mode( ) is not selected in cooling only models. Centralized Controller The centralized controller is an optional accessory and it is installed on the wall. To use the centralized controller, refer to an appropriate manual. Operating lamp All On button All Off button On/Off indicators On/Off buttons Index Note Operating lamp comes on when at least one air conditioner connected to the centralized controller is operating. E-8 Operating Recommendations ENGLISH E-9 Here are a few recommendations that you should follow when operating your air conditioner. Topic Heating performances Recommendation The heat pump function of the air conditioner absorbs heat from outside air and brings it indoors. As the temperature of the outside air drops, the heating performance of air conditioner will decrease. If you find that the room is not warm enough, using an additional heating appliance is recommended. When outside temperature is low but humidity is high, frost may form on the outdoor unit at HEAT mode. x The defrost mode will be triggered automatically for about ten minutes. Note When you have installed the Bio-Pure filter, do not allow any liquids to contact the filter. Note You can use all 4 points of the indoor unit for installing the front grille and the safety clips depending on your requirement. After cleaning the air conditioner, press the Filter Reset button. Note Wired Remote Controller Wireless Remote Controller E-11 Bio-Pure Filter Installation (Optional) The air conditioner can be fitted with a Bio-Pure filter to remove minute dust particles. The service life of the filter is approximately three months depending on the time during which the air conditioner is used. 1 Remove the vinyl packing from the filter. Note Do not remove the packing from a bio-pure filter until you wish to use the filter, as it will lose its properties. 2 Open the front grille by pulling the tabs on the grille. 3 Remove the front grille. 3-2 Open the front grille about 45° and pull it forward. 4 Pull out the air filter. 5 Locate the bio-pure filter on the center of air filter. 6 Secure the bio-pure filter with four screws. 7 Reinstall the air filter, the front grille and the safety clips. E-12 Solving Common Problems ENGLISH Before contacting the after-sales service, perform the following simple checks. Problem Explanation/Solution The air conditioner does not x Check that the breaker used for the air conditioner is switched on. operate at all Wired Remote Controller The air conditioner does not x is displayed on the wired remote controller. In this case, operate with the remote turn the air conditioner off and contact your dealer. [. . . ] controller Wired Remote Controller When turning on/off the air conditioner, it is not turned on/off immediately. x In case of using the wired remote controller for a group, the air conditioners connected to the remote controller are turned on/off in order. Thus, it takes some time(up to 32 seconds). Wireless Remote Controller The air conditioner does not x Check that there are no obstacles between you and the remote operate with the remote control sensor. [. . . ]