User manual DANBY DDR401

[. . . ] If the remote control will not be used for a long time, remove the batteries. Users of this product are cautioned not to attempt repair of this product at their own discretion. Instead, they are requested to directly contact a designated service center or the outlet at which the product was purchased. If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. [. . . ] x Push the battery cover on the rear of the remote control with your thumb and remove it. button. Using a small pointed tool (ball-point pen for example), Press the Result: The AM indication flashes. or 3 To set the current time, press the the remote control. buttons under the cover on Then. . . Increase the time in one-minute intervals Increase the time in ten-minute intervals Decrease the time in one-minute intervals Decrease the time in ten-minute intervals Result: AM or PM is displayed to indicate whether the setting corresponds to a time before or after midday. 4 When you are satisfied with your setting, confirm the time. To do so: using a small pointed tool (ball-point pen for example), press the button. Result: x The clock starts. Resetting the Time If you have already set the time but wish to change it, proceed as follow. 1 Using a small pointed tool (ball-point pen for example), press the button under the remote control flap. Result: 2 3 The AM or PM indication flashes. Set the time, following the instructions in Step 3 in the procedure above. To do so, press the button, using a small pointed tool (ball-point pen for example). x The clock starts. E-8 Selecting the Automatic Operating Mode You can start the air conditioner in Automatic mode from your remote control. In the Automatic mode, the standard temperature and the optimum fan speed is selected automatically. x The indoor unit beeps each time you press x The air conditioner starts up in Dry mode. To stop the blade moving up and down, press the button again. 3 Note If you switch the air conditioner. . . Reset to the position that you previously selected. Adjusting the Air Flow Direction Horizontally There are two sets of inner air flow blades. Just as the outer air flow blade can be adjusted vertically, the inner blades can be adjusted horizontally. 1 Open the air flow blade along the bottom of the indoor unit, by pressing the button. To stop the blade moving up and down, press the button again. 2 3 Adjust each set of inner blades to the required position, by pushing or pulling them sideways. E-14 Switching the Unit On and Off Automatically (On/Off Timer) You can set the timer to switch the air conditioner on and/or off automatically at given times. Example: You wish to start cooling your room before you return from work; you decide to: x Switch the air conditioner on at 5:30 p. m. You can set: x The switch-on time only x The switch-off time only x Both the switch-on and switch-off times IM IMPORTANT Check that the current time is correct before setting the timer; if it is not correct, refer to page 8 for details on how to set it. (On/Off) button. 1 2 If necessary, press the Select the required mode by pressing the MODE button on the remote control one or more times until the appropriate indication appears (in the above example, ). If you do not press a button within a few seconds, the Timer function is cancelled and you must press the button again. Hold down the w button. MODE TURBO 3 OFF 4 To set the switch-on time, press the To. . . [. . . ] Result: x x button one or more times until the current time indication is The indoor unit beeps each time you press The air conditioner operates normally. OFF . MODE TURBO OFF E-17 Operating Recommendation Here is a recommendation that you should follow when using your air conditioner. Topic Power failure Recommendation If a power failure occurs when the air conditioner is operating, the unit is switched off. When the power returns, you must press (On/Off) to restart it. Temperature and Humidity Ranges The following table indicates the temperature and humidity ranges, within which the air conditioner can be used. The automatic protection feature may be triggered and the air conditioner stopped. [. . . ]