User manual DANBY DAC10033TTW

[. . . ] Check available power supply and resolve any wiring problems BEFORE installing and operating this unit. This 115V air conditioner uses 10. 1 or less (depending on model) nameplate amps and may be used in any properly wired, general purpose household receptacle. For your safety and protection, this unit is grounded through the power cord plug when plugged into a matching wall outlet. If you are not sure whether your wall outlet is properly grounded, please consult a qualified electrician. [. . . ] Therefore, it is recommended to have someone assist you during the installation of this unit. Your unit is designed to evaporate condensation under normal conditions. However, under extreme humidity conditions, excess condensation may cause basepan to overflow to the outside. The Unit should be installed where condensation run-off cannot drip on pedestrians or neighboring properties. Installation Select the Best Location A. This room air conditioner is designed to fit easily into a single or double hung window. However, since window designs vary, it may be necessary to make some modifications for safe, proper installation. Make sure window and frame are structurally sound and free from dry and rotted wood. For maximum efficiency, install the air conditioner on a side of a house or building which favors more shade than sunlight. If the unit is in direct sunlight, it is advisable to provide an awning over the unit. Provide sufficient clearance around the cabinet to allow for ample air circulation through the unit. The rear of the unit should be outdoors and not in a garage nor inside a building. Keep unit as far away as possible from obstacles/obstructions and at least 30" (76. 2 cm) above the floor or ground. *`Auto' is a pre-set factory program that automatically defines the mode (Cool or Dry) and fan speed based on the set temperature. FAN SPEED: Select from four different fan settings; Check Filter Sleep Mode Auto Auto Low , Medium , High and Auto Auto during Cool and Fan Only mode. Please note: During `Dry' mode the fan speed is automatically defined . ENERGY SAVER: Automatically cycles the fan on and off while the compressor is not in use. /TIMER Control: Used to increase or decrease the Temperature setting in 1°C / °F increments. and Auto-Timer On/Off settings in 30 min. /1hr. increments. MODE Mode Selector Fan Speed Energy Saver Power Button AUTO-TIMER: Used to Initiate the Auto On and/or Auto Off timer. Press the Auto-Timer button once and the adjacent Auto-On indicator light ` ` will illuminate. Use the Temp/Timer control cursors to select a delayed On time of up to 24 hours. Select the appropriate mode under which you want the unit to operate (Auto-Cool-Dry-Fan Only) 4. Press the Auto-Timer button twice and the adjacent Auto-Off indicator light will illuminate. Use the Temp/Timer control cursors to select a delayed Off time of up to 24 hours. The time you selected will appear in the LED display The Auto On and Auto Off timer can operate during the same program by defining the Auto-Off parameters immediately after the Auto On parameters. [. . . ] Use of a mild detergent is recommended. 9 Troubleshooting Guide Frequently, a problem is minor and a service call may not be necessary, use this troubleshooting guide for a possible solution. If the unit continues to operate improperly, call Danby's Toll Free Number 1-800-263-2629 for assistance, or call one of our service depots listed in the enclosed "Authorized Service Depot" listing provided with this unit. Difficulty Air conditioner will not operate. Possible Cause No power to unit. Suggested Solution Check connection of power cord to power source. Check fuse or circuit breaker. Inefficient or no cooling. Dirty air filter. Power interruption, settings changed too quickly, or compressor overload tripped. Clean or replace air filter. [. . . ]