User manual DANBY D2000

[. . . ] Thank you for choosing a Danby appliance to provide you and your family with all of the "Home Comfort" requirements for your home, cottage or office. This Owner's Manual will provide you with valuable information necessary for the proper care and maintenance of your new appliance. If properly maintained, your Danby appliance will give you many years of trouble free operation. Please take a few moments and read the instructions thoroughly and familiarize yourself with all of the operational aspects of this appliance. [. . . ] 3) Press the appropriate or key to set a dehumidifying temperature between 10°C (50°F) to 30°C (88°F). The green indicator light will come on indicating the dehumidifying mode is operational (there may be a slight delay of 10-30 seconds before the cycle begins, this is normal). IMPORTANT: The temperature selected should always be set a few degrees lower than the room ambient temperature, to ensure normal dehumidifying operation. However, it is not recommended to operate your Dehumidifier, below temperatures of 15. The fan motor operates at a pre-set speed, which registers as MED in the LCD window. When the tank is full, the unit will sound a signal (8 beeps) and the Water Full indicator light start flashing. Carefully remove the water tank from the cabinet and dispose of the water. Replace the water tank back to it's original position (in cabinet) and the Dehumidifying process will automatically resume. 5) This unit also has provisions for a continuous "drain" option (for basement applications having a floor drain). The "red" light will stop flashing automatically when the water tank has been emptied and/or correctly re-positioned. Each depression of the MODE key will advance to a different mode setting (Cool-Dry-Heat-Fan). Before setting the AUTO-ON timer, the TIME OF DAYCLOCK must be set/operational. 2) Select the appropriate MODE under which you want the unit to operate (Cool-Dry-HeatFan). 3) Select the appropriate FAN SPEED setting, under which you want the unit to operate. (Hi, Med, Low) (excluding Dehumidifying, as this mode has "1" fan speed setting only). 4) If you desire oscillation (auto-swing) push the SWING key pad (the "air swing" symbol will be displayed in the display window). 6) To set the AUTO-ON timer, the unit must be turned to the "off" position (non-operational). When the desired time is established, (the time will flash in the display window) press the CLOCK key pad to register the AUTO TIMERON program. the word ON will stop flashing and remain "on" (TIMER ON) indicating the program is set. The time of day clock setting will immediately revert back in the display window. IMPORTANT: The desired AUTO-ON time must be registered within a 5 second period (after pressing the TIMER-ON key pad) otherwise the selected time will not register and the system will automatically revert back to the regular "time of day" clock setting. The unit will start automatically when the specified AUTO-ON time is achieved on the time of day clock (the "TIMER ON" prompt will disappear from the display window). [. . . ] sPECIALNOTE: (Air Conditioner & Dehumidifier Modes Only) · This unit can operate without the secondary external water tank being installed, providing the primary "internal" water tank is correctly installed. This unit cannot operate if the secondary external water tank is installed, but the primary internal water tank is not. nOTE: · The quick connect fittings supplied with both the main unit and external water tank are "self-sealing" connections. This means as soon as the quick connects are "disconnected", water flow between the main unit and external water tank stops immediately. [. . . ]