User manual CREDA HBH250

[. . . ] As a result LPG cylinders, whether partially or completely full, must not be installed or stored in rooms or storage areas that are below ground level (cellars, etc. It is advisable to keep only the cylinder being used in the room, positioned so that it is not subject to heat produced by external sources (ovens, fireplaces, stoves, etc. Fitting the appliance Gas and mixed hobs are manufactured with type X degree protection against overheating. The following precautions must be taken when installing the hob: • Kitchen cabinets adjacent to the appliance and taller than the top of the hob must be at least 600 mm from the edge of the hob. [. . . ] Only use pipes and seals that comply with current national regulations. When the installation process is complete, check the pipe fittings for leaks using a soapy solution. Adapting to different types of gas To adapt the hob to a different type of gas other than default type (indicated on the rating plate at the base of the hob or on the packaging), the burner nozzles should be replaced as follows: 1. Unscrew the nozzles using a 7 mm socket spanner, and replace them with nozzles for the new type of gas (see table 1 “Burner and nozzle characteristics”). Reassemble the parts following the above procedure in the reverse order. Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. replacing the nozzles on separate “double flame “ burners: 1. The internal burner has a nozzle, the external burner has two (of the same size). Replace the nozzle with models suited to the new type of gas (see table 1). Replace the nozzles with models that are configured for use with the new type of gas (see Table 1). Replace all the components by completing the above operations in reverse order. Moreover the double flame crown provides a more uniform distribution of heat on the bottom of the pan, when using both burners on minimum. To ensure that the double-flame burner is used to its full potential, never set the inside ring to minimum and the outside ring to maximum at the same time. In the case of the smaller pots and pans we recommend the use of only the internal burner. For roasting (average) For roasting (above average) --------For browning and reaching a boil in a short time Pans to be used on 60 cm hobs Burner Reduced Rapid (RR) Semi-Rapid (S) Auxiliary (A) Semi-Fishburner (SP) Triple Crown (TC) Ultra Rapid (UR) Double Flame (DCDR internal) Double Flame (DCDR external) Ø Cookware Diameter (cm) 24 - 26 16 - 20 10 - 14 16 - 20 24 - 26 24 - 26 10 - 14 26 - 28 2 3 4 5 6 Pans to be used on 75 cm hobs !On the models supplied with a reducer shelf, remember that this should be used only for the Double flame internal (DCDR internal) burner when you use casserole dishes with a diameter under 12 cm. To identify the type of burner, refer to the designs in the section entitled, "Burner and Nozzle Specifications". Before using the hotplates for the first time, you should heat them at maximum temperature for approximately 4 minutes, without placing any pans on them. During this initial stage, their protective coating hardens and reaches its maximum resistance. Practical Advice on Using the Half Fish-Kettle Burner * The two "Half Fish-Kettle" burners, are eliptic in form and can be turned up to 90°. To turn the two burners 90°, proceed as follows: • Make sure that the burners are cool; • Lift the burner completely out of its housing; • Replace it in its housing in the position desired; • Make sure that the burners are positioned correctly before use. 22 In addition, the two burners can be used in tandem or speartely with cookware of different shapes and sizes: • Double burner for a fish-kettle or oval cookware (Fig. [. . . ] € Do not close the glass cover (if present) when the gas burners or electric hotplates are still hot. Disposal • When disposing of packaging material: observe local legislation so that the packaging may be reused. € The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. [. . . ]