User manual CREATIVE NOMAD JUKEBOX C

[. . . ] Getting Started Getting Started NOMAD Jukebox Information in this document is subject to change without notice and does not represent a commitment on the part of Creative Technology Ltd. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, for any purpose without the written permission of Creative Technology Ltd. The software described in this document is furnished under a license agreement and may be used or copied only in accordance with the terms of the license agreement. It is against the law to copy the software on any other medium except as specifically allowed in the license agreement. [. . . ] For Windows, when the software installation screen appears, select Creative Jukebox Tutorial. For Macs, when the software installation screen appears, select NJBdemo. When the tutorial screen appears, click on a topic to run it. Setting Up NOMAD Jukebox 6 Step 4: Install Software Windows Install all the programs in the installation CD before accessing the software. To install the software for Windows: 1. The Creative PlayCenter 2 setup screen appears with the applications to be installed selected by default. Follow the instructions on the screen to continue with the installation. A message appears after the first application is installed, informing you that the Creative PlayCenter 2 Setup is completed. When prompted to restart your system, leave the CD in the CD-ROM drive, select the "Yes, I want to restart my computer now" option and then click the Finish button. When the Jukebox Installation screen appears, double click on the SoundJam MP Installer icon. NOTE: SoundJam's Installer may detect earlier versions of SoundJam, in which case it is best to select OK and install over the older version. Restart your system when prompted. Macintosh Setting Up NOMAD Jukebox 7 Step 5: Verify NOMAD Jukebox Driver Installation Windows To check that the NOMAD Jukebox driver was successfully installed in Windows: 1. Click the Start button on the Windows Taskbar and select Settings, and click on Control Panel. On the Device Manager tab page, double-click "Universal Serial Bus controllers, " and then check that Creative NOMAD Jukebox is listed. Macintosh To check that the NOMAD Jukebox driver was successfully installed in Macintosh: 1. On the desktop, double-click on the hard disk icon where SoundJam MP has been installed. Check that Creative NOMAD Jukebox is listed. Setting Up NOMAD Jukebox 8 Step 6: Connect Headphones Headphones are not bundled with your NOMAD Jukebox. To connect the headphones to the NOMAD Jukebox: 1. Insert the headphones jack into the connector on the right side of the NOMAD Jukebox. Put on your headphones. Step 7: Select and Play a Track NOMAD Jukebox can only be accessed through its control buttons when it is disconnected from the computer. If NOMAD Jukebox is connected to the computer, use PlayCenter 2 or SoundJam to control the functions of your Jukebox. To play a track preloaded on your NOMAD Jukebox: 1. Turn on the NOMAD Jukebox by pressing and holding the PLAY button until "LOADING" appears in the display. For example, under the Albums category, select "Jukebox Demo". 6. Press the PLAY button to play all tracks in this sub-category. Setting Up NOMAD Jukebox 9 Using Your NOMAD Jukebox Screen Icons The following symbols are used on the NOMAD Jukebox display: Category (Album, Artist, Style, etc. ) List of tracks from an album, a play list, etc. The interactive tutorial on the installation CD is included to guide you through the important operations on NOMAD Jukebox. 3 Single track. PlayPointer appears beside the track or list that is currently being played. NOTE: Should the Battery Charging icon change to the Power Source icon, the batteries are fully charged. [. . . ] You may want to change the configuration later, but for now the default settings will supply excellent quality MP3 files for your NOMAD Jukebox. The "Start converting" button changes to "Stop converting" and the progress of the file conversion is shown in a bar on the lower left of the window. When the conversion is complete, the play list window reopens displaying the newly converted MP3 files. Connect the NOMAD Jukebox to your Mac; the NOMAD Jukebox window opens automatically. [. . . ]