User manual COMPX TS1058BD

[. . . ] The appliance must be installed by a qualified professional according to the instructions provided. Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply. Disposing of combustion fumes The disposal of combustion fumes should be guaranteed using a hood connected to a safe and efficient natural suction chimney, or using an electric fan that begins to operate automatically every time the appliance is switched on (see figure). We recommend cleaning the oven before using it for the first time, following the instructions provided in the "Care and maintenance" section. [. . . ] Replace all the components by following the above instructions in reverse. Remove the knob and adjust the regulatory screw, which is positioned inside or next to the tap pin, until the flame is small but steady. If the appliance is connected to a liquid gas supply, the regulatory screw must be fastened as tightly as possible. Unscrew the nozzle using a special nozzle socket spanner (see figure) or with a 7 mm socket spanner, and replace it with a new nozzle that is suited to the new type of gas (see Burner and nozzle specifications table). Turn the knob to the minimum position (MIN) after it has been in the maximum position (MAX) for approximately 10 minutes. Tighten or loosen the adjustment screws on the outside of the thermostat pin (see figure) until the flame is small but steady. If the appliance is connected to liquid gas, the adjustment screw must be fastened as tightly as possible. Turn the knob from the MAX position to the MIN position quickly or open and shut the oven door, making sure that the burner is not extinguished. V TECHNICAL DATA Oven dimensions (HxWxD) Volume Useful measurements relating to the oven compartment Power supply voltage and frequency 34x38x44 cm 57 l width 42 cm depth 44 cm height 17 cm see data plate may be adapted for use with any type of gas shown on the data plate, which is located inside the flap or, after the oven compartment has been opened, on the left-hand wall inside the oven. Unscrew the grill burner nozzle using a special nozzle socket spanner (see figure) or preferably with a 7 mm socket spanner, and replace it with a new nozzle that is suited to the new type of gas (see Burner I and nozzle specifications table). After adjusting the appliance so it may be used with a different type of gas, replace the old rating label with a new one that corresponds to the new type of gas (these labels are available from Authorised Technical Assistance Centres). Turn the TIMER knob in a clockwise direction 4 for almost one complete revolution to set the buzzer. Turn the TIMER knob in an anticlockwise direction 5 to set the desired length of time. Lower compartment* There is a compartment underneath the oven that may be used to store oven accessories or deep dishes. The internal surfaces of the compartment (where present) may become hot. In gas cooker models, there is a sliding protection layer A that shields the lower compartment from the heat generated by the burner (see figure). Place the rotisserie support in position 4 and insert the spit in the hole provided on the back panel of the oven. Before using the oven make sure that the sliding protection is fixed correctly. 20 Analogue timer* Clock with Country Style timer How to reset the correct time The oven must be plugged in. The programmer is electrically powered, therefore in the event of a power shortage, it will stop working for the entire duration of the same. Timer Feature The timer feature allows you to enter a given amount of time from which the timer begins to count down. This feature does not turn the oven on or off; it merely sounds when the time has elapsed. [. . . ] Exhausted appliances may be collected by the public waste collection service, taken to suitable collection areas in the area or, if permitted by current national legislation, they may be returned to the dealers as part of an exchange deal for a new equivalent product. All major manufacturers of household appliances participate in the creation and organisation of systems for the collection and disposal of old and disused appliances. Respecting and conserving the environment • You can help to reduce the peak load of the electricity supply network companies by using the oven in the hours between late afternoon and the early hours of the morning. € Check the door seals regularly and wipe them clean to ensure they are free of debris so that they adhere properly to the door, thus avoiding heat dispersion. [. . . ]