User manual COBRA XRS9530
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual COBRA XRS9530. We hope that this COBRA XRS9530 user guide will be useful to you.
Manual abstract: user guide COBRA XRS9530
Detailed instructions for use are in the User's Guide.
[. . . ] Introduction
Intro
Important Information and Customer Assistance
Operation Customer Warranty
Assistance Important Information
Federal Laws Governing the Use of Radar Detectors It is not against federal law to receive radar transmissions with your Cobra radar/ laser detector. The Communications Act of 1924 guarantees your right to receive radio Secondary Icons transmissions on any frequency. Local laws that contravene this Act, while illegal, may be enforced by your local law enforcement officials until and unless they are prohibited from doing so by federal court action. Operating Instructions Safety Alert Use of this product is not intended to, and does not, ensure that motorists or passengers will not be involved in traffic accidents. [. . . ] The rev point you set will be stored in the unit's memory when power is turned off and recalled each time the power is turned on. NOTE The rev point must be reset if you use your detector in a different vehicle.
Customer Assistance Warranty
To Set the IntelliMute Activation Point Press and hold the IntelliMute button for two seconds. Main Icons Tone Two beeps Voice Set Engine Revs Visual Display Press IntelliMute button again at desired RPMs None
ondary Icons
Notice
Operation
NOTE When initially choosing your IntelliMute activation point, a setting Notice of approximately 300 to 600 RPMs above idle is recommended. Customer Warranty Assistance You can reset the activation point at any time to fit your individual preferences and driving style.
Customer Setting the IntelliMute Activation Point Assistance Your detector must be installed in your vehicle.
Rev your engine to None the level you wish to set (recommend slightly above idle) and hold revs Intro steady Operation for two seconds. At the desired rev level, press and release the Secondary Icons IntelliMute button.
IntelliMute Not Set
IntelliMu. . .
Notice
None
Customer Assistance
Warranty
Three beeps
IntelliMute Set
IntelliMute Set!
Installation
Notice
Caution
CAUTION Do not attempt to set the rev point while driving. Warning Your vehicle should be parked and idling.
Please tr. . .
NOTE If the unit is unable to sense usable pulses within three seconds or if you do not set a rev point within 20 seconds of beginning these steps, IntelliMute will indicate an error and automatically turn off. Tone Four beeps Voice IntelliMute Not Set, Please Try Again followed by IntelliMute Off Visual Display IntelliMute not set Please try again IntelliMute Off
11
IntelliMute Off
IntelliMute must be turned on before setting the activation point. Depending on whether the unit is in Tone Alert or Voice Alert mode, you will hear a series of beeps or voice messages as you follow the steps on page 11.
Intelli
Mute
Off
One beep
10 English
Nothing Comes Close to a Cobra®
Your Detector
Intro Operation
Settings
Customer Warranty
Your Detector
Intro Operation
Settings
Customer Warranty
Assistance Voice/Tone Setting
Assistance Spectre 1, VG-2 Alert Audio Settings, K & Ku Band Detection
You can set your detector to sound alerts with either a Voice or a Tone. You can change settings by using the Mute button.
Secondary Icons
In Voice Alert mode, you will first hear several tones, then a voice message announcing the type of signal detected, followed by more tones. The factory setting is Voice Alert mode.
Notice
The detector is undetectable by police Spectre 1 and VG-2 radar detector detectors and will alert you when such a device is in use near your vehicle. You can choose whether or not you want your unit to Secondary Icons Spectre 1 and VG-2 alerts. show
Spectre 1 and VG-2 On Spectre 1 and VG-2 Off
Spectre1
Notice
Spectre1
& VG2
Dim Button Press and hold for two seconds Mute Button Press and hold for two seconds City Button Press and hold for two seconds
& VG2
On
Off
To Turn Spectre 1 and VG-2 Alerts On and Off While no signal is being detected, press and hold the Dim button for two seconds. Tone Two beeps One beep Voice Spectre VG-2 On Spectre VG-2 Off Visual Display Spectre1 & VG 2 On Spectre1 & VG 2 Off
To Change From Voice Alert to Tone Alert While no signal is being detected, press and hold the Mute button for two seconds. Tone One beep Voice Tone Alert Visual Display None
To Turn K Band On and Off While no signal is being detected, press and hold both the Dim and City buttons for two seconds. Tone Two beeps One beep Voice K On K Off Visual Display K On K Off
To Change From Tone Alert Back to Voice Alert While no signal is being detected, press and hold the Mute button for two seconds again. Tone None Voice Voice Alert Visual Display None
To Turn Ku Band* On and Off While no signal is being detected, press and hold the City button for two seconds. Tone Two beeps One beep Voice Ku On Ku Off Visual Display Ku On Ku Off
Nothing Comes Close to a Cobra® 13
12 English
* The new Ku band may be introduced to North America in the future. To prevent false alerts until it is, the factory default for Ku band detection is off.
Your Detector
Intro Operation
Detection
Customer Warranty
Your Detector
Intro Operation
Detection
Customer Assistance Warranty
Detection Assistance Signals Detected
Secondary Icons
·
Radar Signals, Voice and Visual Displays Type of Signal X Band Radar
Secondary Icons
Voice X Alert K Alert Ka Alert Ku Alert
K Signal Detected Ka Signal Detected
Visual Display X and Signal Strength K and Signal Strength Ka and Signal Strength Ku and Signal Strength
Ku Signal Detected
The tables on the following pages show you the types of Signals your detector will detect, as well as the voice and visual alerts it provides for each of them.
K Band Radar Ka Band Radar Ku Band Radar
Audio Alerts
In Voice Alert mode you will first hear several tones, then a voice message announcing the type of signal detected, followed by more tones. In both Voice Alert and Tone Alert modes, a distinctly different alert tone is used for each type of signal detected (including separate tones for each laser signal). For X, K, Ka and Ku band radar signals, the tones will repeat faster as you approach the signal source. The repeat rate of the tones gives you useful information about the signal detected. (See responding to alerts on page 17. )
Notice
X Signal Detected
Notice
X--2
K---3 -
_ Ka-----5 ---_
_ Ku----4 --
Laser Signals, Voice and Visual Displays Type of Signal LTI 20-20*
Main Icons
Voice Laser Alert Laser Alert Laser Alert Laser Alert
Kustom Signals ProLaser
Visual Display Laser 20/20 Laser UltraLyte Laser Pro Laser Laser Pro Laser 3
Kustom Signals ProLaser III
Visual Display
An indication of the type of signal detected will appear in the DigiView Data Display. During X, K, Ka and Ku alerts, you will also see from 1 to 5 vertical bars, indicating the strength of the signal detected.
Signal Strength Chart
Signal Strength = 1 (Weakest Signal) Signal Strength = 2 Signal Strength = 3
Intro
LTI Ultra-Lyte* Kustom Signals ProLaser* Kustom Signals ProLaser III*
* Your detector provides 360° detection of these signals.
LTI 20-20 Customer Operation Assistance LTI Warranty Ultra-Lyte
Signal Strength = 4
-Signal Strength = 5 (Strongest Signal)
--Secondary Icons
Laser
Laser
Laser
Laser
20/20
UltraLyte
Pro Laser
Pro Laser 3
-----
_ --_ ----Notice
NOTE Beep rate changes with different laser alerts.
14 English
Nothing Comes Close to a Cobra®
15
Your Detector
Intro Operation
Detection
Customer Assistance Warranty
Intro
Operation
Customer Assistance
Your Detector
Intro Operation
Detection
Customer Warranty
Warranty
Strobe and Safety Alert Signals, Voice and Visual Displays Type of Signal 3M Opticom or Tomar*
Secondary Icons
Assistance Instant-On Detection
Secondary Icons
Voice Emergency Vehicle Approaching Emergency Vehicle Approaching Road Hazard Ahead Train Approaching
Emergency Alert Signal Detected
Operation
Visual Display Emergency Vehicle Emergency Vehicle Road Hazard Train
Train Alert Signal Detected
Your detector is designed to detect Instant-On speed monitoring signals, which can suddenly appear at full strength.
Secondary Icons
Notice
Emergency Vehicles Road Hazards Trains
Main Icons
NOTE You should take appropriate action immediately whenever an instant-on alert is given.
Notice
* Your detector provides 360° detection of this signal.
Strobe Alert Notice Display (Flashing)
Intro Customer Assistance
Road Hazard Alert Signal Detected
Warranty
Responding to Alerts
Description Interpretation
Probably police radar
Recommended Response
FULL ALERT
Emergency. . .
Emergency. . .
Road
Train
Tone repeats slowly at first, then speeds up rapidly. [. . . ] (145 g)
* Dimensions and weight measurements are approximate.
This radar detector is covered by one or more of the following U. S. Additional patents may be listed inside the product or pending.
20 English
Nothing Comes Close to a Cobra®
21
Warranty
eration Customer Assistance Warranty
Warranty
Intro
Limited 1-Year Warranty
For Products Purchased in the U. S. A. Cobra Electronics Corporation warrants that its Cobra 12 Band Radar/Laser Detectors, and the component parts thereof, will be free of defects in workmanship and materials for period of one year from the date of first consumer purchase. This warranty may be enforced by the first consumer purchaser, provided that the product is utilized within the U. S. A.
Operation
Customer Assistance
Customer Assistance
Product Service and Trademark Acknowledgement
Warranty
·
Product Service
For any questions about operating or installing this new Cobra product, or if parts are missing. . . PLEASE CALL COBRA FIRST. . . do not return this product to the store! [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE COBRA XRS9530
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual COBRA XRS9530 will begin.