Detailed instructions for use are in the User's Guide.
[. . . ] Introduction
Intro
Important Information and Customer Assistance
Operation Customer Warranty
Assistance Important Information
Federal Laws Governing the Use of Radar Detectors It is not against federal law to receive radar transmissions with your Cobra radar/ laser detector. The Communications Act of 1924 guarantees your right to receive radio Secondary Icons transmissions on any frequency. Local laws that contravene this Act, while illegal, may be enforced by your local law enforcement officials until and unless they are prohibited from doing so by federal court action. Operating Instructions Safety/Strobe Alert Use of this product is not intended to, and does not, ensure that motorists or passengers will not be involved in traffic accidents. [. . . ] Warning
Warranty
In Program mode, go to Set IntelliMute.
Notice
Tone None Two beeps
Visual Display Voice
Installation
Set IntelliMute None
Secondary Icons
Customer Assistance
Press and release the Set/City button to begin setting IntelliMute RPMs.
Press SET at desired RPMs. . . None
Set Engine Revs None
Notice Caution
Main Icons
Rev your engine to the level you wish to None set. Rev the engine slightly above idle and hold revs steady for two seconds. Three beeps None
To Turn IntelliMute Pro On or Off Using Program Mode IntelliMute Set!None IntelliMute Set None
(See Page 7 For Instructions on Using Program Mode)
Intro Operation Customer Warranty
Assistance Press and release either the Select/Dim button to proceed to the next user mode or the Program/Mute button to exit the Program mode.
Secondary Icons
In Program mode, go to IntelliMute Pro.
Tone Two beeps
Visual Display
Voice
IntelliMute Pro On, IntelliMute Pro On then i blinks in the display IntelliMute Pro Off, then i is steady in the display
IntelliMute Pro Off
Setting IntelliMute RRMs
One beep
Intelli Mute
IntelliMute Pro On
IntelliMute Pro Off
Set Intel. . .
PressSET. . .
Notice
NOTE If the unit is unable to sense usable pulses within three seconds or if you do not set a rev point within 20 seconds of beginning these steps, IntelliMute will indicate an error and automatically turn Off.
IntelliMute Not Set
Set!
Intelli
IntelliMute Off
Intelli Mute Pro Off ih NW ih
Nothing Comes Close to a Cobra® 17
Tone One beep One beep
Visual Display IntelliMute not set Please try again IntelliMute Off
Voice
IntelliMu. . .
Intelli Mute Please tr. . . Off
Mute Pro On NW
IntelliMute not set Please try again IntelliMute Off
16 English
Main Icons
Your Detector
Intro Operation
Settings
Customer Assistance Warranty
Your Detector
Intro Operation
Settings
Customer Assistance Warranty
Compass
Intro
N NW
8-Point Compass
Your detector includes an internal Operation Customer Warranty Assistance 8-point Compass that will continuously display your current direction of travel: Secondary Icons N, NE, E, SE, S, SW, W or NW.
NE
Select/Dim Button Program/Mute Button
Set/City Button
W SW
E SE
Secondary Icons
To Calibrate the Compass Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
Secondary Icons
Calibrating the Compass
S
In Program mode, go to Set Compass. Press and release the Set/City button to begin setting the compass.
Notice
Tone None One (1) beep
Visual Display Voice Set Compass None
Notice
NOTE Notice Before using it for the first time, you must calibrate the compass to provide accurate indications of direction. See page 7 for instructions on using the Program mode to select Set Compass. Calibration allows the compass electronics to measure and store information about the magnetic fields generated by your vehicle.
Drive in 2 Set Compass circles. . . Compass Set For two seconds followed by direction of travel (N, NE, E, SE, S, SW, W or NW) None None
Main Icons
Intro
The compass will remain accurately calibrated as long as your detector is mounted in the same place in your vehicle. If you change the location where the unit Customer is mounted or move it to another vehicle, you must recalibrate the Warranty Operation Assistance compass. The compass temporarily may not provide accurate readings if you are inside a building or enclosure, or are close to a large metal tractor/trailer, truck, or train. Once you are away from such a location, the compass will work correctly again. NOTE When the instructions direct you to drive in two circles, a large parking lot is the most convenient place to do so. It does not matter what direction your vehicle is pointing when you start the circles, which direction you go to make the circles, and it does not have to be exactly two circles. Four three-point turns, two small squares, or any two complete loops will work as well as two circles. It does not matter what size the circles are, if your speed is constant, or how fast you make the circles [but less than two minutes]. Please be careful when making the circles and watch for other traffic.
Within two minutes, drive your vehicle in a circle twice, then press the Set/City button again.
Three beeps
Main Icons
Secondary Icons
Intro
Press and release either the Select/Dim None button to proceed to the next user Operation Customer Warranty mode or the Program/Mute button Assistance to exit Program mode.
Set Compass Calibrate Compass
Compass Set
Direction of Travel
Notice
Secondary Icons
Set Compa. . .
Drive in. . . Press SET. . .
Compass Set!
NW
h
Notice
NOTE If you do not press the Set/City button within two minutes after beginning the set compass process, compass calibration will automatically terminate. Visual Display Voice
Terminate
Tone One beep
Compass not set. . . Please tr. . .
18 English
Nothing Comes Close to a Cobra®
19
Your Detector
Settings
Customer Assistance Warranty
Your Detector
Intro Operation
Settings
Customer Assistance Warranty
Pop Alert
Intro
Operation
VG-2 Alert
The Pop Mode Radar Gun is a single-pulse Doppler radar that is a feature of a K and Ka (Bee III Ka radar gun) band Instant-On radar gun. It uses a single, short-time pulse to measure the target vehicle's speed. [. . . ] Make sure the socket of your vehicle's cigarette lighter is clean and free of corrosion. Make sure the power cord's cigarette lighter adapter is firmly seated in your cigarette lighter. (Unscrew the ribbed end cap of the cigarette lighter adapter and examine the fuse. If required, replace it with a 2-amp fuse only. )
This radar detector is covered by one or more of the following U. S. [. . . ]