Detailed instructions for use are in the User's Guide.
[. . . ] Introduction
Intro
Important Information and Customer Assistance
Operation Customer Warranty
Assistance Important Information
Federal Laws Governing the Use of Radar Detectors It is not against federal law to receive radar transmissions with your Cobra radar/ laser detector. The Communications Act of 1924 guarantees your right to receive radio Secondary Icons transmissions on any frequency. Local laws that contravene this Act, while illegal, may be enforced by your local law enforcement officials until and unless they are prohibited from doing so by federal court action. Operating Instructions Safety/Strobe Alert Use of this product is not intended to, and does not, ensure that motorists or Notice passengers will not be involved in traffic accidents. [. . . ] Warranty Assistance You can reset the activation point at any time to fit your individual preferences and driving style.
Customer Setting the IntelliMute Activation Point Assistance Your detector must be installed in your vehicle.
Intro
Operation
Setting IntelliMute RPMs
Secondary Icons
Set Intel. . .
Press SET. . .
Intelli Mute Set!
Installation
Notice
Caution
CAUTION Do not attempt to set the rev point while driving. Warning Your vehicle should be parked and idling.
Notice
NOTE If the unit is unable to sense usable pulses within three seconds or if you do not set a rev point within 20 seconds of beginning these steps, IntelliMute will indicate an error and automatically turn Off.
Tone One beep One beep Visual Display IntelliMute not set Please try again IntelliMute Off
IntelliMute Not Set
IntelliMute must be turned On before setting the activation point.
IntelliMute Off
Intelli IntelliMu. . . Off
Nothing Comes Close to a Cobra® 15
14 English
Your Detector
Intro Operation
Settings
Customer Warranty
Main Icons
Your Detector
Intro Operation
Settings
Customer Assistance Warranty
Assistance IntelliMute Pro
Compass
Intro Operation
N NW
8-Point Compass
IntelliMute Pro prevents detection by radar detector detectors (RDDs) such as VG-2, Spectre I and Spectre IV+ when traveling at slower speeds. It is intended for use by experienced users only.
OperationSecondary Icons Customer Assistance
When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute activation point, your detector's radar detection circuits are turned Off to prevent detection by RDDs. Before IntelliMute Pro can be turned On, you must have turned On and Set the IntelliMute activation point. (See pages 13 through 15. ) Notice CAUTION When IntelliMute Pro is On, NO radar signals will be detected and NO alerts will be given at RPMs below the IntelliMute activation point. Warning
Warranty
Your detector includes an internal Customer Warranty Assistance 8-point Compass that will continuously display your current direction of travel: Secondary Icons N, NE, E, SE, S, SW, W or NW.
NE
W SW
E SE
Secondary Icons
Installation
Customer Assistance
Calibrating the Compass
S
Notice
NOTE Notice Before using it for the first time, you must calibrate the compass to provide accurate indications of direction. See page 7 for instructions on using the Program mode to select Set Compass. Calibration allows the compass electronics to measure and store information about the magnetic fields generated by your vehicle.
Notice
Caution
Main Icons
To Turn IntelliMute Pro On or Off Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode, go to IntelliMute Pro.
Tone Two beeps One beep
Visual Display IntelliMute Pro On, then i blinks in the display IntelliMute Pro Off, then i is steady in the display
Secondary Icons
Intro
The compass will remain accurately calibrated as long as your detector is mounted in the same place in your vehicle. If you change the location where the unit Customer is mounted or move it to another vehicle, you must recalibrate the Warranty Operation Assistance compass. The compass temporarily may not provide accurate readings if you are inside a building or enclosure, or are close to a large metal tractor/trailer, truck, or train. Once you are away from such a location, the compass will work correctly again. NOTE When the instructions direct you to drive in two circles, a large parking lot is the most convenient place to do so. It does not matter what direction your vehicle is pointing when you start the circles, which direction you go to make the circles, and it does not have to be exactly two circles. Four three-point turns, two small squares, or any two complete loops will work as well as two circles. It does not matter what size the circles are, if your speed is constant, or how fast you make the circles [but less than two minutes]. Please be careful when making the circles and watch for other traffic.
IntelliMute Pro On
IntelliMute Pro Off
Intelli Mute Pro On NW ih
Intelli
Notice
Mute Pro Off NW ih
16 English
Nothing Comes Close to a Cobra®
17
Your Detector
Intro Operation
Settings
Customer Assistance Warranty
Your Detector
Settings
Customer Assistance Warranty
Pop Alert
Set/City Button
Intro
Operation
Select/Dim Button
Secondary Icons
Program/Mute Button
To Calibrate the Compass Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode, go to Notice Set Compass. Within two minutes, drive your vehicle in a circle twice, then press the Set/City button again.
n Icons
Tone None One beep
Visual Display Set Compass Drive in 2 circles. . . For two seconds followed by direction of travel (N, NE, E, SE, S, SW, W or NW) None
The Pop Mode Radar Gun is a single-pulse Doppler radar that is a feature of a K and Ka (Bee III Ka radar gun) band Instant-On radar gun. It uses a single, short-time pulse to measure the target vehicle's speed. Secondary Icons The Pop mode receiver senses Pop singles beyond the effective range of Pop radar guns. As the Pop mode receiver is so sensitive, you should limit the use of Pop Detect mode to highway and rural driving. [. . . ] Make sure the socket of your vehicle's cigarette lighter is clean and free of corrosion. Make sure the power cord's cigarette lighter adapter is firmly seated in your cigarette lighter. (Unscrew the ribbed end cap of the cigarette lighter adapter and examine the fuse. If required, replace it with a 2-amp fuse only. )
This radar detector is covered by one or more of the following U. S. [. . . ]