User manual CITIZEN WATCH C45

[. . . ] Chronograph Mode <CHR> . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Timer Mode <TMR> . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . EL Light . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . When These Problems Occur . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 10bar (B) LIGHT START STOP SET Hours Munites ON/OF (Off) (B) (3) Press button (A) to set the time you want to sound the alarm. (Press and hold button (A) for rapid advancement. ) 12 13 40 35 (A) Hours (B) 30 25 <Sounding Length of Alarm and How to Stop the Alarm Sound> Alarm buzzer will sound for about 20 seconds. Press any button to stop alarm sound. <Sound Monitor> Minutes Alarm will sound while button (A) is kept pressing in Alarm Mode. [Chronograph Reset Display] * If Time Mode is set to 12-hour display system, alarm time also becomes 12hour display system. * Auto-return to Normal Alarm Display will activate when the watch is left in adjustment mode for approximately 2 minutes. * The watch automatically returns to the normal time mode when the alarm state continues for 2 minutes when in the alarm mode. * If button (M) is pressed in adjustment mode, display will immediately return to Normal Alarm Display. Inside paretheses are shown at the time of measurement after 60 minutes <Display of Time Measurement> 60 (M) 50 55 05 10 MODE 45 Chronograph shows "Minutes, Seconds and 1/100 second" up to 59 minutes 59 seconds 99 and will change to "Hours, Minutes and Seconds" after 60 minutes. [Up to 59 minutes 59 seconds 99] (A) 15 CHR (B) 20 SELECT SPLIT RESET W. R. Chronograph Mode <CHR> This chronograph measures up to 23 hours 59 minutes 59 seconds in units of 1/100 second. On reaching 24 hours of elapsed time, it resets to "00 minutes 00 seconds 00" and stops. It can also measure split times (intermediate elapsed time). Minutes (hour) 40 35 30 25 Minute CHR 1/100 second Second Seconds (minute) 1/100 second (second) Hour CHR [After 60 minutes] Second Minute 14 15 <Accumulative Time Measurement> (1) Start/Stop can be repeated for any number of times by pressing button (A). · EL Light will turn "ON" for 4 seconds when counting is stopped by pressing button (A). <Split Time Measurement> (1) Start/Stop can be repeated for any number of times by pressing button (A). · EL Light will turn "ON" for 4 seconds when counting is stopped by pressing button (A). · "SPLIT" will flash while Split Time is being displayed. · EL Light will turn "ON" for 4 seconds when button (B) is pressed. (3) Press button (B) when counting is stopped to reset Chronograph. (B) <Switching the Mode During Chronograph Measuring> Even if button (M) is pressed and the mode is switched while Chronograph is running, the measurement will continue. When you return to the Chronograph Mode, the measured time is again displayed. However, if Chronograph counting has exceeded 24 hours, the watch will return to Chronograph Reset Display. What is Split Time: Intermediate elapsed time from the start. Split Time Split Time RESET (A) MEASURE (B) *1 (A) STOP Start Goal *1: After 10 seconds, automatically returns to the measuring display. (B) SPLIT TIME 17 16 E. Timer Mode <TMR> Timer can be set up to 60 minutes in unit of one minute. Buzzer will sound for 5 seconds when countdown is up and display will return to initial set time. [Timer Set Display] 60 <To Use Timer> <To Set Timer> (M) 50 55 05 10 MODE TMR Press button (B) in Timer Set Display when set time is flashing. Set time digits decrease by one minute, so display the time you want to set. Press and hold button (B) for rapid advancement. (A) (1) Press button (A). * The EL light will turn ON when button (B) is pressed while the timer is running. [. . . ] If solvents, such as thinner and benzine, or substances containing such solvents come in contact with the watch, discoloration, melting, cracking, etc. If the watch comes in contact with mercury used in thermometers, the case, band or other parts may become discolored. 10. Accuracy: within ± 20 seconds/month at normal temperature (+5°C~+35°C/41°F~95°F) 4. Operating Temperature Range: 0°C~+55°C (32°F~131°F) 5. [. . . ]