User manual CATEYE TRIPLE SHOT PRO

[. . . ] · When the angle adjustment on the right and left sides is loose, tighten the screw. CAUTION!: Round off the cut edge of the bracket strap to prevent injury. Dial Screw Bracket strap 2 1 Button 2 Attaching/removing the Light unit · Attaching/removing the Light unit Slide the light unit into the bracket as shown. To remove unit after use, pull it out while pressing the button on the bracket. CAUTION!: Make sure the light unit is cool to the touch before removing it. [. . . ] 2. 5 hours (Hi mode) Long press: Turn off * The run time varies with the environment or conditions in which it is used. B How to Adjust Beam Angle Switch Adjust the beam angle to avoid dazzling oncoming traffic by slightly loosening the dial of the bracket. NOTE: · Do not loosen the dial too much, or the bracket strap may come off. · It can also be adjusted 10 degrees to the left and right. B Remaining Battery The color of the battery indicator built into the switch shows how much battery is left. NOTE: When the battery indication becomes red, charge the batteries as soon as possible. Guigeline for the battery indicator 5 Green : More than 50% left Yellow : 50 to 20% left Red : Less than 20%. * The battery indicator is only an estimation of the remaining battery run-time, and varies with the environment or conditions of use. C Charging Indicator To AC Power Outlet C How to Charge Battery unit Important! · If the battery unit is wet, wipe dry with a dry cloth before charging the batteries. · If the charging indicator flashes green, there is a short somewhere in the circuit. · If the charging indicator turns green a few minutes after charging begins or if the indicator continues a fast green flashing, stop charging, unplug the charger from the outlet, and do steps 1 and 2. If the same result occurs repeatedly, the batteries may be deteriorated. · The standard charging time and run time are guideline values and depend on the operating environment. · If the battery unit repeatedly does not meet the proper run time even though it is fully charged, it might be at the end of its operating life. The used battery unit should be disposed of properly according to local regulations. NOTE: Check that the charging indicator flashes red three times as the power lamp turns red. Connect the plug of the battery charger to the plug of the battery unit. · When charging is complete, the indicator light changes from flashing red to green. After charging is complete, make sure to unplug the charger from the AC outlet. Ring 4 LOCK 2 SPECIFICATIONS Light source ----------------------------------Battery unit -----------------------------------Battery charger ------------------------------Operating time -------------------------------Three High-Power White LEDs Rechargeable lithium-ion battery/7. 4V, 4600mAh CHR-2300/4600mAh Li-ion (AC100V-240V 50/60Hz) Approx. 5 hours (in the case of Low) Standard charging time ---------------------- Approx. 5 hours Temperature range --------------------------- Charging: 41°F ­ 104°F(5°C ­ 40°C) Operating: 5°F ­ 113°F (-15°C ­ 45°C) Recharge/discharge number of times ----- About 300 times (until the rated capacity drops to 70%) * The specifications and design are subject to change without notice. Charging indicator state Standard charging time Approx. 5 hours SPARE PARTS #534-1856 #534-1857 Red light / Blinking green light : Charge error Red light / Red light : Charging Red light / Green light : Charging is completed #534-1856 #534-1857 Light unit Battery unit (lithium-ion batteries 4600mAh) #534-1858 Battery unit (lithium-ion batteries 2300mAh) #533-8827 H34 Bracket UL:#037-5895 / UK:#037-5896 / EC:#037-5897 / AS:#037-5899 Lithium-ion battery charger #534-1860 Battery fixing strap CAUTION!: Use only genuine spare parts from CATEYE. FOR SAFE OPERATION · Never short-circuit the terminals of the battery unit or the battery charger. It may cause the unit to overheat, resulting in fire or damage to the component. If liquid leaks from the batteries, do not touch them with bare hands and do not bring them close to fire. [. . . ] To return the product, pack it carefully and enclose the warranty certificate (proof or purchase) with instruction for repair. Please write or type your name and address clearly on the warranty certificate. Insurance, handling and transportation charges to CatEye shall be borne by person desiring service. For UK and REPUBLIC OF IRELAND consumers, please return to the place of purchase. [. . . ]