User manual CATA CATHPR8111X

[. . . ] Dévissez la vieille ampoule et l'éliminer d'une façon sure et écologique ; la changer pour une du type spécifié dans les Informations Techniques et remonter le protecteur. Therefore, we suggest you read the instructions and suggestions contained in this manual carefully in order to use our products correctly. The specifications plate for this oven is available on this appliance. This plate, visible by opening the door, displays all the necessary identification information for this appliance for ordering replacement parts. [. . . ] This function is used to cook according to the desired finishing time. The oven is adjusted to the desired cooking function and temperature degree. 1) Press " " button until you see "End" on the timer screen. ) 3) Press " " button to confirm, the day `s time will appear On the screen and the symbols "A" " " will light on the screen. Change time means cancle automatice progamme and enter into corresponding mode. If you need to reset automatic mode, need to stop setting the current mode, to set the automatice mode according to the above steps again. Spectification 1) Long press on "+" or "-" for more than 3 seconds, the date will progressively and rapidly increase or decrease in the rate of 5 seconds. 2) When setting each of the time function, if there is none operation for 5 minutes then it will return to manual mode. 3) When setting each of the time function, pressing on " " for more than 3 seconds can cancel current setting and enter manual mode. 4) During time function setting, pressing on "+"and " " for more than 3 seconds, a beep sounds it can cancle the curent time function setting and enter standby mode. 5) We suggest that you run the oven elements for 15 minutes at 200 degrees to burn off any residuce from their surfaces. Clock Setting After connectiong the unit to the power, the symbols 00:00 will be visible on the display. 2) Rotate "K2" to adjust the hour figures, (Time should be within 4) Rotate "K2" to adjust the minutes setting, (time should be After connected to the mains power, the clock will untimed. Function Setting 1) Rotate "K1" to choose the cooking function you require. 4) If step 2 is ignored, Press " " to confirm the start of cooking. And the default time is 9 hours, the default temperature will display on the LED. NOTE: 1) The step quantities for the adjustment time of the coding switch are as follow: 0--0:30min: step 1 minute 0:30--9:00hour: step 5 minutes 2) The step quantities for the adjustment of temperature is 5ºC, and the radiant grilling function is 30ºC. 3) Rotate "K1" to adjust the cooking time when cooking begins. If " " not pressed within 3 seconds, the oven will revert back to the previous time to continue cooking. 4) Rotate"K2 " to adjust the temperature when cooking begins. If " " not pressed in 3 seconds, the oven will revert back to the previous temperatrue to continue cooking. Lamp Setting 1) Rotate "K1" to select the relevant function, then the Inquiring function During cooking process, you can use inquiring function, after 3 seconds return to the current working state. [. . . ] The conductors of the network power supply lead are coded by colours are follows: Green and yellow -Earth Blue - Neutral Brown - Live Remove the rear part of this section D. The green and yellow conductor must be connected to the terminal marked "E" or with the symbol of the earth or which is green and yellow. The blue conductor must be connected to the terminal marked "N". The brown conductor must be connected to the terminal marked "L". [. . . ]