User manual CAT EYE CC-7000 (VECTRA)

[. . . ] (All Clear a ). Standard Parts #169-6590 Parts Kit ENG Wireless Sensor The sensor was designed to receive signals within a limited range to prevent sensor signal interference. If the temperature or battery power is low, they may need to be even closer than normal. The sensor must be installed at the top of the fork, and the distance between the sensor and the computer should not exceed approximately 70 cm. [. . . ] (Take into account the angle of the stem. ) Interference may occur, resulting in malfunction, if the computer is: · Near a TV, PC, radio, motor, or in a car or train. · Close to a railroad crossing, railway tracks, TV stations and or radar base. · Close to a second bicycle with wireless sensors. #169-6580 Speed Sensor A #169-6570 Bracket kit Correct installation of sensor and magnet A Attach the magnet 3 so that it passes through the sensor zone of the sensor 2. B Be sure to have a 5 mm-or-less clearance between the sensor 2 and magnet 3. Replacing the Battery · Computer If the Wheel Size icon ( or ) flashes, replace the battery. Install a new lithium battery (CR2032) with the (+) side facing upward. Then re-start the computer according to the SET UP procedure, and then set the clock from the MENU FLOW. Then check the positions of the battery and magnet. #169-9691 Wheel Magnet Part names A Current Speed B Sensor signal reception icon C D #166-5150 Lithium Battery (CR2032) E G H I J Flashes in sync with sensor signals. Sub measurement icon Pace arrow Indicates whether the current speed is faster or slower than the average speed. ( Faster Slower) Auto mode icon Speed unit Mode symbol . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . b Press the MODE button to switch measurement according to the OPERATION FLOW. Press the MODE button for 2 seconds to switch from Main to Sub measurement. · Sub measurement When Main measurement starts/stops, Sub measurement starts/ stops accordingly. Note, however, that the main and sub measurements must be reset individually. Resetting Main and Sub measurement at different times allows interval measurement to be carried out. * In the sub measurement the pace arrow compares the current speed to average speed 2. CO. , LTD. 2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 Japan Attn: CATEYE Customer Service Section Resetting data . . . . . . . . . . . . . . . . . . . . . . . . . . . Main : c Sub : d To reset measurement data, display the Main/Sub measurement data and press the START/STOP and MODE buttons simultaneously. Trip distance is not reset. Backlight Press the backlight button to illuminate the display for 3 seconds. [. . . ] If the battery is low, the wheel size icon flashes and the display does not illuminate. Service & Research Address for USA CATEYE Service and Research Center 1705 14th St. 115 Boulder, CO 80302 Phone: 303. 443. 4595 Toll Free: 800. 5CATEYE Fax: 303. 473. 0006 E-mail: service@cateye. com URL: http://www. cateye. com Power-saving function If the computer has not received a signal for 10 minutes, powersaving mode will activate and only the clock will be displayed. When the computer receives a sensor signal again, the measuring screen reappears. [. . . ]