User manual CASABLANCA FAN COMPAGNY ZEPHAIR

[. . . ] This appliance has a grounded three-prong plug and is suitable for grounded receptacle use only. An adaptor is available from your local hardware store for connecting three-prong grounding-type plugs to two-slot receptacles. Improper installation may result in a risk of fire, electrical shock, or personal injury. This product is intended for household use only and not for commercial or industrial use. ASSEMBLY INSTRUCTIONS Table & Desk Fan: No assembly required. [. . . ] Thread and tighten the collar for the base of the fan, tighten completely. b) You may need to adjust the alignment of the knob at the back of the motor housing with the cord coming out of the base as you tighten the collars. The proper alignment of the notches in step 5 and step 10 will help keep this alignment as you tighten the collars. Set the floor fan up where the cord will not be in a traffic area or tripped on. Also make sure the oscillation movement of the cage is not impeded in any way. Step 5 TAB NOTCH Step 5 Step 8 Step 9 NOTCH TAB Step 10 OPERATING INSTRUCTIONS 1. Place the fan on a safe, flat surface where it cannot fall or be pulled by the cord. To set the horizontal direction of airflow, hold the fan housing neck in one hand, make sure the oscillating knob is in the up position and then turn the cage left or right. To control the vertical direction of airflow, grip the handle on top of the fan tightly and loosen the wing nut on the side of the fan housing neck. To make the fan oscillate, push down on the oscillating knob located on the top of the fan housing, near the handle. To stop the fan from oscillating, pull up on the oscillating knob. 6a. To sleect a speed on the table model move the switch lever located on the base of the fan from OFF to the desired speed setting of 1 (low), 2 (medium) or 3 (high). To select a speed on the floor model, move the switch knob located on the back of the motor housing from OFF to the desired speed setting of 1 (low), 2 (medium) or 3 (high). OPTIONAL: To store the excess cord, unplug the fan from the wall socket and gently lay the fan on its side, making sure that the cage and motor are properly supported. Gently pull the cord through the bottom rubber bushing (assuring it remains in place) and through the cord restraint until you have the desired length. If the rubber bushing in the base has come loose, reinstall it into the base of the fan. Re-align the cord restraint to the proper position to reattach it to the base with the screw. Replace the base bottom, aligning the screw holes and reinstall the screws, assuring that no wires or cord are pinched. FOR TABLE & DESK FAN: FOR FLOOR FAN: SCREWS RUBBER BUSHING CORD RESTRAINT SPEED SWITCH ASSEMBLY CORD RESTRAINT SCREW USER MAINTENANCE & CLEANING This fan is permanently lubricated and will not require additional lubrication (oil) for the life of the fan. This appliance requires little maintenance and contains no user serviceable parts. [. . . ] Should it become necessary to return your fan to an authorized Casablanca Service Center make sure it is properly packaged to avoid in-transit damage, which is not covered by this warranty. This warranty does not apply if the product has been damaged by improper installation, neglect, accident, misuse, exposure to extremes of heat of humidity, or as a result of service or modification by other than an authorized Casablanca service center. All costs of installing, removing and reinstalling the product are the responsibility of the owner. Casablanca will not pay for shipping charges incurred in sending the defective product from the customer to Casablanca Fan Co. , but will pay for return UPS shipment. [. . . ]