User manual CASABLANCA FAN COMPAGNY S3

[. . . ] For best performance and for your warranty to be valid, use only genuine Casablanca blades, light fixtures, and accessories. SAFE USE · The blades in each pack are matched for equal weight to assure smooth fan operation. If more than one fan is being installed, be careful not to mix blades from different cartons. · Inspect the contents of your carton for possible shipping or handling damage and report any such damage directly to your authorized Casablanca dealer. · It is always a good idea to have an assistant to help with the installation. [. . . ] CAUTION: To reduce the risk of personal injury, use only the mounting hardware provided with the approved outlet box to install the crossbar mounting bracket. CEILING FAN APPROVED WIRING BOX CEILING WIRING RIDGE SIDE DOWN CROSSBAR MOUNTING BRACKET GREEN GROUND WIRE FLAT WASHER APPROVED OUTLET BOX HARDWARE CANOPY HARDWARE CANOPY SCREW (4) CANOPY HATCH CANOPY LOCK WASHER (4) CANOPY 4 S3TM CANOPY INSTALLATION Step 2. Attach the canopy to the crossbar mounting bracket with three of the 8-32 x 21/4 long canopy screws and canopy lock washers. Note: On sloped ceilings, align the canopy opening towards the top or room peak. CROSSBAR MOUNTING BRACKET CANOPY CANOPY LOCK WASHER CANOPY SCREW BLADE HARDWARE BLADE SCREW (3 PER BLADE) METAL WASHER (3 PER BLADE) BLADE (3) BLADE INSTALLATION Step 3. Assemble the blades to the motor using the 3 blade screws and 3 metal washers. Hand tighten firmly. BLADE SCREW & WASHERS 5 HANGING THE FAN Step 4. To hang the fan body in the canopy, hold the fan body firmly and insert the ball into the canopy opening. Rotate the fan body until the slot in the nylon ball fits into the pin opposite the canopy opening. BALL NOTE: The fan weight is 23 pounds. PIN SLOT CANOPY ELECTRICAL CONNECTIONS Step 5a. Attach the fan wires to the ceiling fixture outlet box wiring by twisting the bare ends of the wires together and then securing with a wire nut. Wiring Connections · GREEN leads from mounting plate and fan to GROUND conductor of power source. · WHITE wire from fan to white NEUTRAL wire in ceiling fixture outlet box. · BLACK power wire from fan to BLACK power wire in ceiling outlet box. Secure with wire nut. 2 BLACK WIRES 2 WHITE WIRES WIRE NUT 3 GREEN WIRES CANOPY HATCH INSTALLATION Step 6. Tuck the wires into the canopy with the wire nuts pointed upwards, so that the WHITE and BLACK wires are on opposite sides of the canopy and all wires are clear of the canopy opening. Straighten the fan, then check to ensure that there is no movement between the canopy and ceiling or Hang-Tru ball and top support shaft. CANOPY HATCH LOCK WASHER CANOPY SCREW TILT THE FAN TO INSTALL LAST CANOPY SCREW 6 6 S3TM INSTALL BULB AND GLASS Step 9. Do not touch the glass bulb with your fingers­it is extremely important that the glass be clean. When installing the halogen bulb, carefully cut off the end of the plastic sleeve the bulb comes in and hold the bulb by the plastic sleeve to screw it into the socket. TABS HALOGEN BULB 100 WATT Step 10. Position the indentations in the outer rim of the glass shade so that they line up with the tabs on the inside surface of the fan light fixture rim. Carefully lift the glass shade up inside the light fixture as far as it will go. Note: The wall anchors and 6-32 x 1" screws may be used in situations where mounting to a stud is not possible. After securing the anchor, discard the anchor's pointed screws and use the 6-32 decor ovalhead screws supplied. ANCHOR PANHEAD SCREW Control Storage Angle control in top first in the holder until the unit can be gently pushed back and snapped onto the bottom rim. TOP GOES IN FIRST DRYWALL ANCHOR WOOD SCREW 1" DECOR OVALHEAD SCREW 6-32 X 1" Removing Gently Pull the lower edge of the control gently out from the holder. VERSA·TOUCH o BATTERY INSTALLATION Remove Battery Door Turn control on its front. Replace the battery door. GUIDE SLOTS SNAP PLUG SOCKET Changes or modifications not expressly approved in writing by Casablanca Fan Co. may void the user's authority to operate this equipment. 8 8 VERSA·TOUCH OPERATION Fan Control To start the fan. [. . . ] FAN AND LIGHT ON FULL, NO CONTROL; Defective receiver; Replace Receiver. FAN OPERATES ONLY WHEN TRANSMITTER IS CLOSED: Check antenna wire is not touching metal plate. FAN STARTS WORKING BY ITSELF: Frequency interference; Change frequency as described on Page 9. For questions or to locate the nearest Casablanca Authorized Service Center call toll free: 1-888-227-2178 or visit us on the web at: www. CasablancaFanCo. com 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 2. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ]