User manual BREVILLE VCF149X

[. . . ] The use of an accessory not recommended by the appliance manufacturer for use with this appliance may result in fire, electric shock or injury to persons. Do not let cord hang over edge of table or counter, or touch hot surfaces. Do not place on or near a hot gas or electric burner, or in a heated oven. Always attach plug to appliance first, then plug cord into the wall outlet (for appliances with detachable cords). [. . . ] Turn the Control dial to the "brew" position the unit will begin to dispense automatically. The brew status indicator will illuminate for the duration of the dispense cycle. When the desired amount of coffee has been dispensed turn the Control dial to the `Standby' position. NOTE: coffee will continue to flow for a short time after the Control dial has been moved to the `Standby' position, as coffee drains from the portafilter. Fill the water tank to the "MAX" marking with clean, filtered water. NOTE: Any type of milk can be used ­ soy, rice, almond, coconut, etc. NOTE: The ready indicator light will pulse while the water is heating up. Once the unit reaches the correct temperature, the ready indicator light will turn solid. Turn the Control dial to steam, and steam will be emitted from the steam wand. NOTE: After steaming milk, the unit must be allowed to cool for a few minutes, or the cool down cycle operation performed as it will be too hot to make coffee. It is recommended when making multiple drinks with steamed milk, you should make the espresso shots first, before steaming the milk. Remember to clean the milk frothing For instructions on how to do so, please referTUtRoN the cleaning section. Tip just below the surface of the And milk pitcher or cup at an Angle that allows thTUeRNmilk to move in a whirlpool pattern. As the milk level rises, lower the Milk pitcher or cup to keep the Milk frothing wand tip just below After steaming, the unit will be too hot to immediately make coffee again. The brew button indicator light will flash rapidly when pressed, and the unit will not dispense if the Control dial is moved to the brew position. The unit can be left to cool naturally for a few minutes, or the following procedure performed. Press the brew button, the indicator light will be flashing to indicate the unit is over temperature 4. Move the Control dial clockwise to the steam position, Steam will begin to dispense. The unit automatically starts its cool down cycle, the pump will operate in pulses passing shots of steam then water through the steam wand. Once the unit has cooled sufficiently the brew button indicator light will illuminate solidly, and water will stop being dispensed from the steam wand. YToUuRNr Breville Bijou Espresso machine can dispense hot water from the steam wand for use when making long coffee drinks. Place you cup with your espresso shot In on the worktop and place the end of the steam wand inside. [. . . ] Water will be dispensed continuously for 60 seconds, the unit will then automatically stop dispensing. Turn the control dial back to the `Standby' position, discard the water. Water will dispense continuously for 60 seconds, the unit will then stop dispensing. Turn the control dial back to the `standby' position, discard the water. [. . . ]