User manual BREVILLE URN10

[. . . ] Breville Urn Breville is a registered trademark of Breville Holdings Pty. Limited ABN 98 000 092 928 Breville Customer Care Centre Australian Customers Breville Customer Care Centre Locked Bag 2000 Botany NSW 2019 Australia Customer Service Ph: 1300 139 798 Fax (02) 9384 9601 Email Customer Service askus@breville. com. au New Zealand Customers Breville Customer Service Centre Private Bag 94411 Greenmount Auckland, New Zealand Customer Service Ph: 09 271 3980 Fax 0800 288 513 Email Customer Service askus@breville. com. au ¤ ¤ PRINTED ON RECYCLED PAPER © Copyright. Limited 2004 Due to continual improvements in design or otherwise, the product you purchase may differ slightly from the one illustrated in this booklet. Model URN6/URN10 Issue 2/00 INSTRUCTIONS FOR USE MODEL URN6/URN10 BREVILLE RECOMMENDS SAFETY FIRST Congratulations on your purchase of a new Breville Urn. [. . . ] · Do not immerse cord, plug or base in water or any other liquid. · Always switch the appliance to off, switch the power off at the power outlet and then remove the plug when the appliance is not being used and before cleaning. · If supply cord, plug or actual appliance becomes damaged in any way, return the entire appliance to the nearest authorised Breville Service Centre for examination, replacement or repair. · Any maintenance other than cleaning should be performed at an authorised Breville Service Centre. KNOW YOUR BREVILLE URN 1. Capacity (Urn6 - 6 litres, Urn10 - 10 litres) Stainless steel body 1800 watt concealed element Non-drip tap with 2 way pouring action External water gauge Variable heat control Locking lid with ergonomic handles 9. Automatic boil dry cut out protects against overheating (safety reset button is under the base) Power `on' and `heating' lights 10. 10. 2 3 OPERATING YOUR BREVILLE URN BEFORE FIRST USE It is recommended that before the first use, the Urn is filled to the maximum level, boiled and water discarded. Place the Urn on a dry level surface and position the drip tray at the front of the Urn (tilt the Urn back and slide the drip tray under to secure in place fig 1). OPERATING YOUR BREVILLE URN (CONTINUED) Do not fill above the maximum fill line on the external water gauge as boiling water may splash out from the Urn. NOTE! NOTE! The lid should always be fitted and locked into position when in use. Use caution when pouring water from your Urn, as boiling water will scald. Do not open the lid when in operation as steam may escape from the top. 4. After filling the Urn, ensure that the lid is replaced and locked into position. When the unit has boiled, select the desired setting from `Low' to 7 to maintain temperature. The heating light will illuminate on and off maintaining the temperature selected. To fill with water, turn the locking lid anticlockwise and remove (fig 2). [. . . ] Fig 7 CARE AND CLEANING Always switch the appliance to off, switch the power off at the power outlet and then remove the plug before cleaning. Never immerse the Urn controls or cord in water, or allow moisture to come in contact with these parts. REMOVAL OF MINERAL DEPOSITS. Mineral deposits in tap water may cause the Urn interior to discolour. This may be removed by using a commercial kettle descaler which is available from most leading supermarkets, departments and hardware stores. TO CLEAN THE POLISHED EXTERIOR. The stainless steel surface may be wiped over with a damp cloth and polished with a soft dry cloth. NOTE! Do not use chemical, steel wool, or abrasive cleaners to clean the outside of the Urn. 6 7 [. . . ]