User manual BREVILLE PRIMA LATTE VCF045X

[. . . ] CAUTION In order to avoid possible burns, scalds and/or other injury from hot steam and water, or damage to the unit, never remove the water tank, milk tank or the filter holder while the appliance is brewing coffee or frothing milk. Wait until the brew cycle is complete before removing any of these parts. If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. If the fuse in a moulded plug needs to be changed, the fuse cover must be refitted. [. . . ] filling the filter holder Make sure that the filter and filter holder are completely dry. Fill the filter with fresh ground coffee using the measuring scoop (fig. Use the flat end of the scoop to tamp (compress) the coffee firmly and evenly (fig. The coffee should be approximately 3 mm below the rim of the filter when correctly tamped (fig. Clean any excess coffee from the rim of the filter holder so that it will seal properly when the filter holder is fitted to the brewing head. If the pod has a tab or flap, fold it inside the filter so it doesn't stick out. fitting/removing the filter holder Position the filter holder under the brewing head with the handle lined up with the unlocked symbol ( ) on the unit (fig. Move the handle to the right as far as it will go until it lines up with the locked symbol ( ) on the unit. To remove the filter holder, move the handle to the left until it is lined up with the unlocked symbol ( ). To empty the used coffee from the filter holder, position the filter lock over the rim of the filter and hold it in place with your thumb (fig. This will hold the filter in place so you can invert and tap the filter holder to remove the used coffee. Add the ground coffee and tamp it down or, if using pods, place a pod into the pod filter. Your espresso will be brewed and when the brewing cycle has finished, the three buttons will light up. mAKING CAPPUCCINO Cappuccino is made with about Espresso, steamed milk and frothed milk. For a large Cappuccino fit the double shot filter otherwise, use the single Add the ground coffee and tamp it down. Add milk to the milk tank then position the froth tube over the cup using the lever. For a large Cappuccino, press the button twice the large cup icon ( ) will light. Your Cappuccino will be brewed and when the brewing cycle has finished, the three buttons will light up. For a large Latte fit the double shot filter otherwise, use the single shot or Add the ground coffee and tamp it down or, if using pods, place a pod into the pod filter. Add milk to the milk tank then position the froth tube over the cup using the lever. For a large Latte, press the button twice the large cup icon ( ) will light. Your Latte will be brewed and when the brewing cycle has finished, the three buttons will light up. [. . . ] Melkebeholderen har en tett passform, og du er nødt til å holde hovedenheten for å kunne bruke tilstrekkelig stor kraft for å presse den helt inn. For grovt kvernet og vannet flyter gjennom kaffen for raskt og gir svak smak og lys farge. Melkebeholderen har en tett passform, og du er nødt til å holde tak i hovedenheten for å kunne bruke tilstrekkelig stor kraft for å presse den helt inn. Bruk én enkelt skje for en enkeltshot og to skjeer for en dobbelshot. [. . . ]