User manual BREVILLE BCG450XL

[. . . ] ⷠTo protect against electric shock, do not immerse the grinder, plug or cord in water or any other liquid. ⷠRemove any promotional stickers or packaging materials before using the coffee grinder for the first time. ⷠDo not place the appliance near the edge of a bench or table during operation. ⷠTo turn the appliance off, remove the plug from the power outlet. [. . . ] Return the entire appliance to the nearest authorised Breville service centre for examination and/or repair. The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance. With transparent window With suggested coffee style settings Before first use Before first use, remove any promotional stickers or packaging material attached to your coffee grinder. Remove the Bean Container, Bean Container Lid and Ground Coffee Container and wash in warm soapy water with a soft cloth. Before each use, ensure Grinding Chamber and Ground Coffee Container are clean and empty. Remove the Burr Grinder inside the Grinding Chamber by gripping the small inner black plastic frame and pulling out the top ring. Using a soft cloth, wipe off any excess protecting oil from the Burr Grinder and place it back into the Grinding Chamber. Place the Bean Container into the Grinding Chamber so the `ALIGN' arrow on the Bean Container aligns with the `ALIGN' arrow on top left-hand side of the Grinder. Measure the desired quantity of whole coffee beans or spices directly into the Bean Container and cover with Bean Container lid. To select the desired fineness of grind, rotate the Bean Container and align the white marker on the front panel of the Grinder with one of the following settings: COARSE MEDIUM FINE EXTRA FINE SUPER FINE ­ Percolator ­ French Press ­ Filter ­ Espresso ­ Turkish NOTE: In order to remove any excess protecting oils from the Burr Grinder, it is necessary to grind 1. The Coffee Grinder will begin grinding the coffee/spices directly into the Ground Coffee Container and will stop automatically when grinding is complete. To stop the grinding cycle at any time, push the `START' button again. If the `START' button is pressed again, the grinder will start from the beginning of the timed cycle. Gently tap the side of the Grinder, above the Ground Coffee Container, so that any grinds remaining in the release chute are released into the Ground Coffee Container. Remove the Bean Container, Bean Container Lid and Ground Coffee Container and wash in warm soapy water with a soft cloth. Wipe the Grinding Chamber with a soft dry cloth and replace the Bean Container, Bean Container Lid and Ground Coffee Container back into position. Rewind the power cord into the cord storage area located under the Grinder base. To ensure optimal grinding performance, allow Coffee Grinder to cool for at least 2 minutes between uses. Vary the type of coffee beans, amount of coffee and fineness of grind to find the flavor you prefer. [. . . ] HWI Breville ® expressly disclaim all responsibility for consequential damages for incidental losses caused by use of this appliance. Some states or provinces do not allow this exclusion or limitation for incidental or consequential losses, so the foregoing disclaimer may not apply to you. This warranty gives you specific legal rights and you may also have other legal rights which vary from state to state or province to province. If the appliance should become defective within the warranty period, do not return the appliance to the store. [. . . ]