User manual BOSCH WFF 1101

[. . . ] If you have any questions especially with respect to installing and connecting your washer dryer please do not hesitate to contact our customer service department. Further information and a selection of our products can be found on our internet page: http://www. bosch hausgeraete. de Please read these operating and installation instruc tions and all other information enclosed with the was her dryer and act accordingly. These operating and installation instructions describe various models. Retain all documentation for subsequent use or for the next owner of the appliance. 3 Information concerning waste disposal Disposing of the packaging The shipping package has protected your new appliance on its way to your home. [. . . ] The steps for changing the settings are described in detail overleaf. Overview at a glance Load the laundry and close the loading door. Select programme with programme selector. Spin speed Page 30 or without final spin Start time Page 31 can be set in 1-hour steps Signal Page 34 on off loudness Make further settings or press the M button. Childproof lock Page 33 on off 29 Spin speed You can reduce the displayed spin speed. q If required, press the button(s) for additional option(s). Example of Easy Care A 40 ºC programme: i The following is indicated in the display field: - programme status display, - recommended load, - maximum spin speed, e. g. q Load the laundry and close the loading door. q Press the B button until the required spin speed, e. g. i If setting "---" (without final spin) has been selected, the washing remains in the final rinsing water. Before the laundry can be unloaded, the b Drain or B Spin programme must be performed. i The speed can be changed at any time by pressing the B button until the new speed is displayed. Setting "---" (without final spin) is possible until the Rinse programme section starts. 30 Start time Before a programme starts, you can specify by how many hours the start of the programme is to be delayed. q If required, press the button(s) for additional option(s). Example of Easy Care A 40 ºC programme: i The following is indicated in the display field: - programme status display, - recommended load, - maximum spin speed, - programme duration, 1:00 (1 hour). 1'h (h=hour) appears in the display. q Press the W button until the desired number of hours is displayed. If a start time of 19'h has been set, the programme duration mode can be accessed by pressing the W button again. 31 You can change other settings or q Press the M button. i If a programme is interrupted at a high temperatu re, á Rinse/Freshen up should be selected to cool down the laundry. i If a programme was interrupted at a high temperature, such as drying programme, the washer dryer door may remain locked until the appliance has cooled down. 36 After washing/drying i Display panel: - all symbols on the programme status display have gone out, the full progress bar is displayed, - the programme duration is on -0-, - if the childproof lock is selected, the G symbol illuminates, - if detergent was overdosed, the : symbol illuminates. q Turn the programme selector to Off. or Setting "---" (without final spin) selected i Display panel: - the B symbol and the full progress bar are indicated on the programme status display, - the programme duration is on "---". - if the childproof lock is selected, the G symbol illuminates, - if detergent was overdosed, the : symbol illuminates. q If required, deactivate the childproof lock. 37 q Select an additional programme b Drain or B Spin. At the end of the additional programme: q If required, deactivate the childproof lock. q Turn the programme selector to Off. Removing the laundry q Open the washer dryer door. If the loading door cannot be opened: Wait 2 minutes (safety function is active) or there is still water in the washer dryer if the "---" (without final spin) option was selected. q Leave the washer dryer door and detergent dra wer open to allow the interior of the washer dryer to dry. After drying: q Take the laundry out of the machine immediately to prevent creasing. Cottons + Linens Cotton and linen items which have been dried to iron dry should be rolled together to prevent them from drying out completely before they are ironed. [. . . ] They will fall to the floor when you tip the machine. q Insert the covers. 56 Built under or built in appliance installation The appliance must be built under or built in prior to connecting the power supply. q The washer dryer must only be installed under a one piece worktop that is permanently attached to the surrounding cabinets. Attention For safety reasons in built under installation, a cover plate* must be assembled by a specialist in place of the appliance cover plate. * Cover plate (set) can be obtained from a specialist store or the Customer Service, order no. [. . . ]