User manual BOSCH SRI3015

[. . . ] Household Appliances Internet: http://www. bosch-hausgeraete. de Bosch Info-Team: DE Tel. DTAG) 5600 053 180 (8211) en Instructions for Use en Index 4 6 7 8 9 10 11 Detergents . Filling the special salt container Filling the rinse-aid container Unsuitable dishes . . en Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. [. . . ] Products which eliminate the need for regeneration salt can only be used within a certain water hardness range. If you wish to use these combined products, please read the instructions carefully and heed any notes on the packaging. Contact the manufacturer of the cleaning agent if you have any questions, particularly if: the crockery is very wet once the programme has finished. Any problems which arise as a direct result of the use of these products are not covered by our warranty. If you are using detergent in tablet form, read the manufacturer's recommendations on the packaging in order to determine where the tablets should be placed inside the dishwasher (e. g. Make sure that the lid on the detergent compartment is closed, even if you are using tablets. 14 en Programme overview This overview lists the max. The programmes supplied with your appliance are indicated on the fascia. Type of food remains Soups, casseroles, sauces, potatoes, pasta, rice, eggs, roast or fried food a lot stuck on hard Mixed Soups, potatoes, pasta, rice, eggs, roast or fried food a lot a little Soak with water if dishes have been left inside dishwasher for several days before they are washed Amount of food remains Condition of food remains loosely attached Wash programme Intensive 65° Normal 65° Eco 65° Pre-rinse Programme sequence Pre-rinse 65° Pre-rinse Wash 65° Intermediate rinse Rinse-aid 65° Drying Pre-rinse Wash 65° Intermediate rinse Rinse-aid 65° Drying Wash 65° Intermediate rinse Rinse-aid 65° Drying Pre-rinse Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc. , as well as the amount and condition of food remains, with the details contained in the programme overview. If only a small number of dishes have been loaded into the dishwasher, selecting a programme that operates at the next lowest temperature will usually suffice. 15 en Programme data The programme data (duration, energy and water consumption) can be found in the summary of instructions and refers to standard conditions. Greater deviations may be caused by: different quantities of utensils inlet temperature of the water water pressure ambient temperature mains voltage tolerances and appliance-specific tolerances (e. g. temperature, water flow rate, etc. ) The water consumption values refer to water hardness value 2. Washing the dishes Switching on the appliance Turn on the tap fully. Select a programme with the programme selector 1 (rotate in a clockwise direction only). The programme starts. Programme sequence indicator While the dishes are being washed, the programme selector rotates in a clockwise direction and indicates how far the programme has progressed. End of programme The programme has ended when the pump noise is no longer audible and the programme selector has reached its initial position (12 o'clock position). Switching the dishwasher OFF Several minutes after the programme has ended: Set the main switch 5 to OFF. (Does not apply when Aqua­Stop unit has been fitted) It is not necessary to reset the programme selector. when they have cooled down. 16 en Interrupting the programme Set the main switch 5 to OFF. If the hot water was switched ON or the appliance has already heated up and then the appliance door opened, leave the door ajar for several minutes and then close. In order to resume the programme, set the main switch to ON again. Maintenance and care You can help prevent faults by checking and maintaining your appliance regularly. Therefore you should occasionally examine the inside of your dishwasher. Overall condition of the appliance Check the rinsing compartment for grease and limescale deposits. If you find any deposits: Fill the detergent dispenser with detergent. Start the empty appliance with the programme which has the highest rinsing temperature. Clean the door seal: Wipe the door seal regularly with a damp cloth and remove any deposits. Changing the programme Switch off the main switch 5 . Set the programme selector 1 to the new programme (rotate in a clockwise direction only!). Note If the power supply is disconnected while the appliance is operating, e. g. [. . . ] If the appliance is not connected via a plug, the installation side must feature an all-pole disconnector with a contact gap of at least 3 mm in order to satisfy the relevant safety regulations. Installation The dishwasher must be connected by a qualified technician to ensure correct operation. The specifications for supply, drainage and connected load must fulfil the required criteria as stated in the following paragraphs or in the installation instructions. Install the appliance in the following sequence: ­ Check the delivery ­ Install the appliance ­ Connect the waste water ­ Connect the fresh water ­ Connect the power supply Delivery Your dishwasher was checked at the factory to ensure that it was in perfect working order. These will disappear after the first rinse cycle. Installation The required installation dimensions can be found in the installation instructions. [. . . ]