User manual BOSCH SMV 63M70EU/81 SUPPLEMENT

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual BOSCH SMV 63M70EU/81. We hope that this BOSCH SMV 63M70EU/81 user guide will be useful to you.


BOSCH SMV 63M70EU/81 SUPPLEMENT: Download the complete user guide (740 Ko)

You may also download the following manuals related to this product:

   BOSCH SMV 63M70EU/81 INSTALLATION INSTRUCTIONS (2221 ko)
   BOSCH SMV 63M70EU/81 INSTALLATION INSTRUCTIONS (2221 ko)

Manual abstract: user guide BOSCH SMV 63M70EU/81SUPPLEMENT

Detailed instructions for use are in the User's Guide.

[. . . ] 42-34362 (5 micron): Sediment cartridges remove sand, silt, clay, dirt, and other sediments from water. The 25 micron cartridge filters larger sediments from water, and al lows higher flows at less pressure drop. Taste and Odor Cartridges: Many bad tastes and/or odors are removed from water by an activated carbon cartridge. It is most often used to remove chlorine taste and smell, usually to a single faucet such as the kitchen cold. [. . . ] n existing plumbing type (copper, threaded, etc. ) and nominal size (1/4", 3/8" etc. ) n tools you have, and your plumbing skills n cost of materials needed n space available for installing the filter housing Sears has optional kits available to make installing the water filter housing easier (see below and page 5). 42-34387 - Includes 3/8" fittings and tubing, water supply saddle valve, and a separate faucet for filtered water. 42-34388 - (in cluded with deluxe model) Make a simple sketch of your proposed installation, and a list of plumbing materials you will need. Be sure you have the tools required. TYPICAL UNDERSINK INSTALLATIONS / TOOLS AND MATERIALS NEEDED FIG. 1 INSTALLATION ON COPPER PLUMBING USING COMPRESSION FITTINGS SINK compression elbow Mounting Bracket ­ includes screws, Sears Item No. 42­34388 (included with Deluxe model) apply several wraps of Teflon tape FILTERED WATER HOT COLD brass ferrule compression adaptor (use elbow or straight fitting) nut shutoff valve Note: To change the filter cartridge, you must turn off the water. Most sinks already have shutoff valves on the supply pipes. apply several wraps of Teflon tape INLET WATER IN 3/8" NPT Note: Be sure to allow a minimum space of 1­1/2" under the filter for removing the sump, to change the cartridge. ¤ 4 ­ MATERIALS AND TOOLS NEEDED ­ " 2 compression adaptors (either straight fittings as shown, or elbows), 3/8" NPT x comp. (compression end to fit existing pipe) Note: Sears has an installation kit available that fits 3/8" O. D. " Teflon tape " tubing cutter " sandpaper or emery­cloth " 2 wrenches, either open end or adjustable jaw, size to fit compression adaptors TYPICAL UNDERSINK INSTALLATIONS / TOOLS AND MATERIALS NEEDED FIG. 42­34387 FAUCET (filtered water) Mounting Bracket ­ includes screws, Sears Item No. 42­34388 (included with Deluxe model) IN OUT « « HOT COLD adaptor, 3/8" NPT x sweat (apply several wraps of Teflon tape to threads) ­ MATERIALS AND TOOLS NEEDED ­ (see page 6) HOT SINK adaptor saddle valve adaptor shutoff valve COLD nut brass ferrule compression adaptor FIG. Protect the filter housing from soldering heat, as you did above, and complete the connections (D) to the faucet cold water pipe. Before turning on the water supply, remove the sump from the filter head and install the filter cartridge (see page 7). 6 INSTALLATION STEPS (cont. ) C. 3 MATERIALS AND TOOLS NEEDED: For threaded pipe installation, you will need pipe wrenches, Teflon tape or pipe joint compound, a union fitting and pipe nip ples. Observe the following: H Use Teflon tape or pipe joint compound on all exter nal threads. H Do not turn pipe or fittings to tightly into the filter head or you may break it. This will allow you to tighten the union fitting, without damaging the filter head, if pipe lengths are not exact. H Before turning on the water supply, remove the sump from the filter head and install the filter cartridge (see below). D. If not, close the main water shutoff valve near the water meter or pressure tank. ) 2. If plumbing with flexible tubing, hang or support the filter housing in some manner. Using the mounting bracket (included with Deluxe model) as shown in FIG. If using rigid pipe, be sure to allow a minimum of 1-1/2" clearance under the fil ter for sump removal when changing the filter car tridge. Use the plumbing procedures on pages 5 and 6 if using compression fittings. [. . . ] However, no matter which type of cartridge you are using, you will know it is time to replace it when you first no tice the return of the unwanted substance in your water. Sediment Cartridges: Average cartridge life, when filtering water to 1 faucet, is about 6 months. Then, disassemble the filter and check the o-ring for cuts, flat spots, etc. , and sealing surfaces for foreign material. Taste and Odor Cartridges: A taste and odor car tridge contains activated carbon, a black powder. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE BOSCH SMV 63M70EU/81




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual BOSCH SMV 63M70EU/81 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.