User manual BOSCH SGS53A02GB

[. . . ] Household Appliances Internet: http://www. bosch-hausgeraete. de Bosch Info-Team: DE Tel. DTAG) 5600 048 214 (8206) en Instructions for Use en Index Detergents . 10 en Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. The wooden frames (if fitted) are made of residual wood and are untreated. [. . . ] Type of food remains Soups, casseroles, sauces, potatoes, pasta, rice, eggs, roast or fried food a lot stuck on hard medium Mixed Delicate Mixed Soups, potatoes, pasta, rice, eggs, roast or fried food Coffee, cakes, milk, sausage, cold drinks, salads very little Amount of food remains Condition of food remains Wash programme a little Rinse off if the dishes have been stacked for several days in the dishwasher prior to washing. loosely attached Intesive 70° Auto 55° /65° Eco 50° Gentle 40° Quick 35° Pre-rinse The programme sequence is optimized and adapted with how the appliance is loaded and how dirty the dishes are. Programme sequence Pre-rinse 50° Wash 70° First rinse Second rinse Third rinse Rinse-aid 70° Drying Pre-rinse Wash 50° Main rinse Rinse-aid 65° Drying Pre-rinse Wash 40° Main rinse Rinse-aid 55° Drying Wash 35° Main rinse Rinse-aid 55° Pre-rinse Drying Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc. , as well as the amount and condition of food remains, with the details contained in the programme overview. You will find the appropriate programme information in the introduction. 15 en Washing dishes Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc. , as well as the amount and condition of food remains, with the details contained in the programme overview. The corresponding programme sequence, duration and consumption details are shown in the bottom half of the overview. For example: For a mixture of various types of crockery and utensils with plenty of food remains that are not stuck on fast, use the programme. If only a small number of dishes have been loaded into the dishwasher, selecting a programme that operates at the next lowest temperature will usually suffice. Aquasensor * * on applicable models The Aquasensor is an optical measuring device with which the cloudiness of the water in the dishwasher is measured. A photoelectric sensor is used to detect the degree of soiling in the water, caused by dissolved food particles such as egg, fat and rolled oats, etc. The Aquasensor functions during all programmes that include a pre-rinse cycle. If the water is still "clean" at the end of the pre-rinse cycle, then the same water is used for the following wash cycle. If the water is dirty, it is pumped out of the dishwasher and replaced by fresh water. 5 litres when the dishes are only "slightly" dirty. Switching the dishwasher ON Turn on the tap. Indicators light up according to the last programme that was selected. This same programme will run again if no other programme button 6 is pressed. For appliances with top basket feature: If only the top basket is loaded, press the top-basket button 5 . The programme starts automatically. Programme data The stated programme data are based on standard operating conditions. The values can vary considerably according to: different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage machine-related factors (e. g. Energy and water consumption is reduced by up to 1/4 when dishes are washed in the upper basket only. Water consumption values are based on a water hardness setting of 4. End of programme The programme has ended when a figure appears in the numerical display 3 . 16 en Switching the dishwasher OFF Several minutes after the programme has ended: Set the main switch 1 to OFF. (Does not apply when Aqua-Stop unit has been fitted) Remove dishes, etc. when they have cooled down. Programming the timer You can delay the start of a programme in increments of one hour for up to 19 hours. Press the TIMER button as many times as necessary until the numerical display shows the required delay. To erase the time delay setting, keep pressing the TIMER button until appears in the numerical display. [. . . ] Install the appliance in the following sequence: ­ Check the delivery ­ Install the appliance ­ Connect the waste water ­ Connect the fresh water ­ Connect the power supply Fresh water connection Using the enclosed parts, connect the fresh water connection to the tap according to the installation instructions. Ensure that the fresh water connection is not kinked, crushed or twisted. When replacing the appliance, always connect a new water supply hose to the water supply. Ensure that the fresh water connection is not kinked, crushed or twisted. [. . . ]