User manual BOSCH SCE63M05GB

[. . . ] Dishwasher 9000 455 889 (8908) en Operating instructions 678 9 h. Reset 3 sec. B h. min. A h. Start C Reset 3sec 1 2 3 4 5 20 21 22 23 24 25 26 27 28 29 30 en en Table of contents Washing the dishes . 14 14 14 14 14 15 15 15 15 15 15 16 16 16 16 17 17 18 18 19 19 19 19 20 21 21 21 22 22 22 22 22 23 23 23 23 24 24 24 Safety instructions . 14 3 en Safety instructions Delivery ­ Check the packaging and dishwasher immediately for damage caused in transit. ­ Please dispose of the packaging material in an environmentally friendly manner. [. . . ] The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). 14 en Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. ­ Press 8 + or ­ button until the displayed time corresponds with your requirements. ­ To delete timer programming, press the 8 + or ­ button until h : is indicated on the digital display. You can change your programme selection at any time until the programme starts. Interrupting the programme ­ Switch off ON/OFF switch (. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the ON/OFF switch ( again. Terminating the programme (Reset) ­ Press START button H for approx. ­ Switch off ON/OFF switch (. End of programme The programme has ended when the value : is indicated on the numerical display h. Switching off the appliance Short time after the end of the programme: ­ Switch off ON/OFF switch (. ­ Remove the utensils when they have cooled down. Changing the programme When the START button H has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. 15 en Intensive drying The final rinse uses a higher temperature which improves the drying result. ­ Hold down programme button # and press START button H until the digital display h : . . . The LED for button # flashes and the digital display h displays the factory setting : . ­ Press programme button # until the factory set value : is indicated on the digital display h. To change the setting, ­ Press the button 3 to switch the Intensive drying on : or off : . The set value is saved. Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Overall condition of the machine ­ Check spray arm for grease and limescale deposits. If you find such deposits: ­ Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. [. . . ] ­ Use only a residual current operated circuit-breaker which features the symbol , . Only this extension guarantees compliance with the currently valid regulations. Please note the system will not function unless the power supply is connected. Transportation Empty the dishwasher and secure loose parts. Drain the appliance according to the following steps: ­ Turn on the tap. [. . . ]